Specification sheet Wheel Loader Ref doosan-m250-v-wheel-loader

Doosan M250-V

The Doosan M250-V is a wheel loader with an operating weight of 30,423.8 lb (13,800 kg), a 163 hp engine, and a 3.14 yd³ (2.4 m³) bucket.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
30,423.8lb
13,800kg
Engine power
163hp
121.6kW
Net Power
Bucket capacity
3.14yd³
2.4m³

Where it sits in its classpercentile · small wheel loaders

Among 439 small wheel loaders (22,000–45,000 lb), the Doosan M250-V sits in the middle of its class:

  • Operating weight 30,420 lb lighter than 52% (n=439)
  • Engine power 163 hp less powerful than 51% (n=408)
  • Bucket capacity 3.1 yd³ smaller-bucket than 53% (n=387)

Scale drawingdrawn to scale · mm

3320B430C7500A
Side elevation
3320B2563D
Front elevation

01 Engine Specification

Number Of Cylinders 6
Engine Make 2253
Net Power 163hp 121.6kw
Gross Power 170hp 126.8kw
Power Measured @ 2200rpm
Max Torque 543lb ft 736.3Nm
Displacement 353cu in 5.8L
Torque Measured @ 1300rpm
Aspiration Turbocharged

02 Operational Specification

Operating Weight 30423.8lb 13800kg
Fuel Capacity 71.4gal 270L
Static Tipping Weight 26455.5lb 12000kg
Operating Voltage 24V
Alternator Supplied Amperage 60amps
Tire Size 20.5/25

03 Transmission Specification

Transmission Type ZF
Number Of Forward Gears 4
Number Of Reverse Gears 3
Max Speed - Forward 23mph 37km/h
Max Speed - Reverse 15.3mph 24.5km/h

04 Hydraulic System Specification

Pump Flow Capacity 31.8gal/min 120L/min
Raise Time 5.3sec
Dump Time 1.2sec
Lower Time 3.3sec

05 Bucket Dimensions

Dump Clearance At Max Raise 12.77ft in 3890mm
Bucket Capacity - Heaped 3.14yd3 2.4m3
Breakout Force 29090.28lb 129.4kN

06 Dimensions Dimensions

Ground Clearance 1.42ft in 430mm
Length With Bucket On Ground 24.61ft in 7500mm
Width Over Tires 8.41ft in 2563mm
Height To Top Of Cab 10.9ft in 3320mm
Wheelbase 9.91ft in 3020mm
Reach At Max Lift And Dump 9.06ft in 2760mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.