Specification sheet Wheel Loader Ref doosan-dl200tc-5-wheel-loader

Doosan DL200TC-5

The Doosan DL200TC-5 is a wheel loader with an operating weight of 26,223.99 lb (11,895 kg), a 142 hp engine, a 2.62 yd³ (2 m³) bucket, and a dig depth of 0.26 ft (80 mm).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
26,223.99lb
11,895kg
Engine power
142hp
105.89kW
Gross Power
Bucket capacity
2.62yd³
2m³
Dig depth
0.26ft
80mm

Where it sits in its classpercentile · small wheel loaders

Among 439 small wheel loaders (22,000–45,000 lb), the Doosan DL200TC-5 sits below the median for its class:

  • Operating weight 26,220 lb lighter than 77% (n=439)
  • Engine power 142 hp less powerful than 73% (n=408)
  • Bucket capacity 2.6 yd³ smaller-bucket than 76% (n=387)

Scale drawingdrawn to scale · mm

3280B440C7315A
Side elevation
3280B2530D
Front elevation

01 Engine Specification

Starter 7.4hp 5.6kw
Number Of Cylinders 6
Engine Make Perkins
Engine Model 1204F
Gross Power 142hp 105.9kw
Power Measured @ 2200rpm
Displacement 268.6cu in 4.4L
Net Torque 413.1lb ft 560Nm
Torque Measured @ 1400rpm
Bore 4.2in 105mm
Stroke 5in 127mm
Alternator 85amps

02 Capacities Specification

Fuel Tank 45gal 170.4L
Diesel Exhaust Fluid (Def) Tank 5gal 19L
Cooling System 8.5gal 32.2L
Hydraulic System 34.1gal 129.1L
Engine Oil 2.8gal 10.6L

03 Operational Specification

Operating Weight 26224lb 11895kg
Front Axle/Diff Fluid Capacity 4gal 15.2L
Rear Axle/Diff Fluid Capacity 3.5gal 13.3L
Static Tipping Weight 18827.5lb 8540kg
Operating Voltage 28V
Tire Size 20.5-R25 (L3)

04 Transmission Specification

Max Speed - Forward 24mph 38.7km/h
Max Speed - Reverse 12mph 19.4km/h

05 Hydraulic System Specification

Maxpumpflow 49gal/min 185.5L/min
Raise Time 5.1sec
Dump Time 2.6sec
Lower Time 4.2sec
Relief Valve Pressure 3190psi 21994.3kPa

06 Bucket Dimensions

Bucket Capacity - Heaped 2.62yd3 2m3
Bucket Width 8.37ft in 2550mm
Breakout Force 21355lb 95kN

07 Dimensions Dimensions

Ground Clearance 1.45ft in 440mm
Width Over Tires 8.31ft in 2530mm
Wheelbase 9.52ft in 2900mm
Hinge Pin - Max Height 12.5ft in 3810mm
Reach At Max Lift And Dump 3.11ft in 945mm
Overall Height 10.77ft in 3280mm
Overall Length 24ft in 7315mm
Digging Depth 3.15in 80mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.