Specification sheet Skid Steer Loader Ref doosan-470-plus-skid-steer-loader

Doosan 470 Plus

The Doosan 470 Plus is a skid steer loader with an operating weight of 7,478 lb (3,391.97 kg), a 75 hp engine, a rated operating capacity of 2,500 lb (1,133.99 kg), and a tipping load of 5,000 lb (2,267.96 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,478lb
3,391.97kg
Engine power
75hp
55.93kW
Net Power
Rated operating capacity
2,500lb
1,133.99kg
Tipping load
5,000lb † — value reconstructed from related published figures
2,267.96kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Doosan 470 Plus sits above the median for its class:

  • Operating weight 7,480 lb heavier than 68% (n=334)
  • Engine power 75 hp more powerful than 76% (n=335)
  • Rated operating capacity 2,500 lb higher-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

2035C218D3248A2557B
Side elevation
2035C1662E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2347
Engine Model B3.3T
Net Power 75hp 56kw
Power Measured @ 2600rpm
Aspiration turbocharged
Displacement 198.9cu in 3.3L

02 Operational Specification

Operational Weight 7478lb 3392kg
Fuel Capacity 15.9gal 60L
Max Speed 7.7mph 12.3km/h
Tire Size 12-16.5-8PR

03 Loader Specification

Breakout Force 4678lb 2122kg
Operating Load Rating 2500lb 1134kg

04 Hydraulic Specification

Pump Type gear type
Pump Flow Capacity 21.7gal/min 82.2L/min
Relief Valve Pressure 3001.5psi 20700kPa

05 Dimensions Dimensions

Length With Bucket 10.66ft in 3248mm
Width Over Tires 5.46ft in 1662mm
Ground Clearance 8.59in 218mm
Height To Top Of Cab 6.68ft in 2035mm
Wheelbase 3.49ft in 1061mm
Length W/O Bucket 8.39ft in 2557mm
Clearance At Max Lift And Dump 7.96ft in 2424mm
Reach At Max Lift And Dump 29.02in 737mm
Turning Radius From Center - Machine Rear 62.21in 1580mm
Turning Radius From Center - Inc Bucket 76.34in 1939mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.