Specification sheet Skid Steer Loader Ref doosan-460-plus-skid-steer-loader

Doosan 460 Plus

The Doosan 460 Plus is a skid steer loader with an operating weight of 6,900.47 lb (3,130 kg), a 69.91 hp engine, a rated operating capacity of 2,391 lb (1,084.54 kg), and a tipping load of 4,782 lb (2,169.08 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,900.47lb
3,130kg
Engine power
69.91hp
52.13kW
Net Power
Rated operating capacity
2,391lb
1,084.54kg
Tipping load
4,782lb † — value reconstructed from related published figures
2,169.08kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Doosan 460 Plus sits in the middle of its class:

  • Operating weight 6,900 lb heavier than 53% (n=334)
  • Engine power 70 hp more powerful than 59% (n=335)
  • Rated operating capacity 2,390 lb higher-rated than 72% (n=288)

◇Scale drawingdrawn to scale · mm

2035C218D3264A2573B
Side elevation
2035C1662E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2348
Engine Model 4TNV98-ZNDS
Net Power 69.9hp 52.2kw
Power Measured @ 2600rpm
Displacement 202.5cu in 3.4L

02 Operational Specification

Operational Weight 6900.5lb 3130kg
Fuel Capacity 15.9gal 60L
Max Speed 7.8mph 12.6km/h
Tire Size 12-16.5-8PR

03 Loader Specification

Breakout Force 4678lb 2122kg
Operating Load Rating 2391lb 1084.6kg

04 Hydraulic Specification

Pump Type gear type
Pump Flow Capacity 21.7gal/min 82.2L/min
Relief Valve Pressure 3001.5psi 20700kPa

05 Dimensions Dimensions

Length With Bucket 10.71ft in 3264mm
Width Over Tires 5.46ft in 1662mm
Ground Clearance 8.59in 218mm
Height To Top Of Cab 6.68ft in 2035mm
Wheelbase 3.49ft in 1061mm
Length W/O Bucket 8.45ft in 2573mm
Clearance At Max Lift And Dump 7.96ft in 2424mm
Reach At Max Lift And Dump 29.02in 737mm
Turning Radius From Center - Machine Rear 62.21in 1580mm
Turning Radius From Center - Inc Bucket 76.34in 1939mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.