Specification sheet Skid Steer Loader Ref doosan-450-plus-skid-steer-loader

Doosan 450 Plus

The Doosan 450 Plus is a skid steer loader with an operating weight of 6,791 lb (3,080.35 kg), a 69.91 hp engine, a rated operating capacity of 2,061 lb (934.86 kg), and a tipping load of 4,122 lb (1,869.71 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,791lb
3,080.35kg
Engine power
69.91hp
52.13kW
Net Power
Rated operating capacity
2,061lb
934.86kg
Tipping load
4,122lb † — value reconstructed from related published figures
1,869.71kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Doosan 450 Plus sits in the middle of its class:

  • Operating weight 6,790 lb lighter than 51% (n=334)
  • Engine power 70 hp more powerful than 59% (n=335)
  • Rated operating capacity 2,060 lb higher-rated than 61% (n=288)

◇Scale drawingdrawn to scale · mm

2035C218D3223A2536B
Side elevation
2035C1662E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2348
Engine Model 4TNV98-ZNDS
Net Power 69.9hp 52.2kw
Power Measured @ 2600rpm
Displacement 202.5cu in 3.4L

02 Operational Specification

Operational Weight 6791lb 3080.4kg
Fuel Capacity 18.5gal 70L
Max Speed 7.8mph 12.6km/h
Tire Size 12-16.5-8PR

03 Loader Specification

Breakout Force 4978lb 2258kg
Operating Load Rating 2061lb 934.9kg

04 Hydraulic Specification

Pump Type gear type
Pump Flow Capacity 21.7gal/min 82.2L/min
Relief Valve Pressure 3001.5psi 20700kPa

05 Dimensions Dimensions

Length With Bucket 10.58ft in 3223mm
Width Over Tires 5.46ft in 1662mm
Ground Clearance 8.59in 218mm
Height To Top Of Cab 6.68ft in 2035mm
Wheelbase 3.49ft in 1061mm
Length W/O Bucket 8.33ft in 2536mm
Clearance At Max Lift And Dump 7.93ft in 2417mm
Reach At Max Lift And Dump 25.83in 656mm
Turning Radius From Center - Machine Rear 61.07in 1551mm
Turning Radius From Center - Inc Bucket 75in 1905mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.