Specification sheet Skid Steer Loader Ref doosan-440-plus-skid-steer-loader

Doosan 440 Plus

The Doosan 440 Plus is a skid steer loader with an operating weight of 6,133 lb (2,781.89 kg), a 47 hp engine, a rated operating capacity of 1,973 lb (894.94 kg), and a tipping load of 3,946 lb (1,789.88 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,133lb
2,781.89kg
Engine power
47hp
35.05kW
Net Power
Rated operating capacity
1,973lb
894.94kg
Tipping load
3,946lb † — value reconstructed from related published figures
1,789.88kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Doosan 440 Plus sits below the median for its class:

  • Operating weight 6,130 lb lighter than 67% (n=334)
  • Engine power 47 hp less powerful than 78% (n=335)
  • Rated operating capacity 1,970 lb higher-rated than 52% (n=288)

◇Scale drawingdrawn to scale · mm

1954C190D3208A2521B
Side elevation
1954C1486E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2347
Engine Model A2300
Net Power 47hp 35.1kw
Power Measured @ 2600rpm
Displacement 139.8cu in 2.3L

02 Operational Specification

Operational Weight 6133lb 2781.9kg
Fuel Capacity 14.3gal 54L
Max Speed 7.3mph 11.8km/h
Tire Size 10-16.5-8PR

03 Loader Specification

Breakout Force 2910lb 1320kg
Operating Load Rating 1973lb 895kg

04 Hydraulic Specification

Pump Type gear type
Pump Flow Capacity 15.8gal/min 59.9L/min
Relief Valve Pressure 3001.5psi 20700kPa

05 Dimensions Dimensions

Length With Bucket 10.53ft in 3208mm
Width Over Tires 4.88ft in 1486mm
Ground Clearance 7.49in 190mm
Height To Top Of Cab 6.42ft in 1954mm
Wheelbase 3.53ft in 1074.8mm
Length W/O Bucket 8.28ft in 2521mm
Clearance At Max Lift And Dump 7.3ft in 2224mm
Reach At Max Lift And Dump 25.4in 645mm
Turning Radius From Center - Machine Rear 63.27in 1607mm
Turning Radius From Center - Inc Bucket 75.08in 1907mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.