Specification sheet Skid Steer Loader Ref doosan-430-plus-skid-steer-loader

Doosan 430 Plus

The Doosan 430 Plus is a skid steer loader with an operating weight of 5,703 lb (2,586.84 kg), a 45 hp engine, a rated operating capacity of 1,505 lb (682.66 kg), and a tipping load of 3,009 lb (1,364.86 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,703lb
2,586.84kg
Engine power
45hp
33.56kW
Net Power
Rated operating capacity
1,505lb
682.66kg
Tipping load
3,009lb † — value reconstructed from related published figures
1,364.86kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Doosan 430 Plus sits below the median for its class:

  • Operating weight 5,700 lb lighter than 74% (n=334)
  • Engine power 45 hp less powerful than 84% (n=335)
  • Rated operating capacity 1,510 lb lower-rated than 69% (n=288)

◇Scale drawingdrawn to scale · mm

1934C190D3047A2371B
Side elevation
1934C1486E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2347
Engine Model A2000
Net Power 45hp 33.6kw
Power Measured @ 2800rpm
Displacement 122cu in 2L

02 Operational Specification

Operational Weight 5703lb 2586.9kg
Fuel Capacity 14.1gal 53L
Max Speed 7.5mph 12.1km/h
Tire Size 10-16.5-6PR

03 Loader Specification

Breakout Force 3139lb 1423.9kg
Operating Load Rating 1505lb 682.7kg

04 Hydraulic Specification

Pump Type gear type
Pump Flow Capacity 11.8gal/min 44.7L/min
Relief Valve Pressure 2537.5psi 17500kPa

05 Dimensions Dimensions

Length With Bucket 10ft in 3047mm
Width Over Tires 4.88ft in 1486mm
Ground Clearance 7.49in 190mm
Height To Top Of Cab 6.35ft in 1934mm
Wheelbase 3.14ft in 957mm
Length W/O Bucket 7.78ft in 2371mm
Clearance At Max Lift And Dump 7.2ft in 2192mm
Reach At Max Lift And Dump 20.4in 518mm
Turning Radius From Center - Machine Rear 60.4in 1534mm
Turning Radius From Center - Inc Bucket 71.03in 1804mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.