Specification sheet Skid Steer Loader Ref daewoo-dsl902-skid-steer-loader

Daewoo DSL902

The Daewoo DSL902 is a skid steer loader with an operating weight of 6,777.01 lb (3,074 kg), a 64 hp engine, a rated operating capacity of 1,999.6 lb (907 kg), and a tipping load of 4,338.7 lb (1,968 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,777.01lb
3,074kg
Engine power
64hp
47.8kW
Gross Power
Rated operating capacity
1,999.6lb
907kg
Tipping load
4,338.7lb † — value reconstructed from related published figures
1,968kg
Bucket capacity
0.6yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Daewoo DSL902 sits in the middle of its class:

  • Operating weight 6,780 lb lighter than 52% (n=334)
  • Engine power 64 hp more powerful than 51% (n=335)
  • Rated operating capacity 2,000 lb higher-rated than 53% (n=288)

◇Scale drawingdrawn to scale · mm

2035C218D3200A2508B
Side elevation
2035C1662E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2253
Engine Model D430
Gross Power 64hp 47.8kw
Power Measured @ 2500rpm
Displacement 181.7cu in 3L

02 Operational Specification

Operational Weight 6777.1lb 3074kg
Fuel Capacity 18.3gal 69L
Max Speed 6.8mph 10.9km/h
Tire Size 12 x 16.5

03 Loader Specification

Breakout Force 5194.1lb 2356kg
Operating Load Rating 1999.6lb 907kg
Bucket Capacity 0.6yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 20.6gal/min 77.7L/min

05 Dimensions Dimensions

Length With Bucket 10.5ft in 3200mm
Width Over Tires 5.46ft in 1662mm
Ground Clearance 8.59in 218mm
Height To Top Of Cab 6.68ft in 2035mm
Wheelbase 3.49ft in 1061mm
Length W/O Bucket 8.23ft in 2508mm
Clearance At Max Lift And Dump 7.81ft in 2378mm
Reach At Max Lift And Dump 27.33in 694mm
Turning Radius From Center - Machine Rear 61.82in 1570mm
Turning Radius From Center - Inc Bucket 76.34in 1939mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.