Specification sheet Skid Steer Loader Ref daewoo-dsl802-skid-steer-loader

Daewoo DSL802

The Daewoo DSL802 is a skid steer loader with an operating weight of 6,594.03 lb (2,991 kg), a 64 hp engine, a rated operating capacity of 1,699.77 lb (771 kg), and a tipping load of 3,593.6 lb (1,630.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,594.03lb
2,991kg
Engine power
64hp
47.8kW
Gross Power
Rated operating capacity
1,699.77lb
771kg
Tipping load
3,593.6lb † — value reconstructed from related published figures
1,630.03kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Daewoo DSL802 sits in the middle of its class:

  • Operating weight 6,590 lb lighter than 55% (n=334)
  • Engine power 64 hp more powerful than 51% (n=335)
  • Rated operating capacity 1,700 lb lower-rated than 64% (n=288)

◇Scale drawingdrawn to scale · mm

2015C218D3177A2508B
Side elevation
2015C1662E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2253
Engine Model D430
Gross Power 64hp 47.8kw
Power Measured @ 2500rpm
Displacement 181.7cu in 3L

02 Operational Specification

Operational Weight 6594.1lb 2991kg
Fuel Capacity 21.2gal 80L
Max Speed 6.8mph 10.9km/h
Tire Size 12 x 16.5

03 Loader Specification

Breakout Force 5467.5lb 2480kg
Operating Load Rating 1699.8lb 771kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 20.6gal/min 77.7L/min

05 Dimensions Dimensions

Length With Bucket 10.43ft in 3177mm
Width Over Tires 5.46ft in 1662mm
Ground Clearance 8.59in 218mm
Height To Top Of Cab 6.62ft in 2015mm
Wheelbase 3.49ft in 1061mm
Length W/O Bucket 8.23ft in 2508mm
Clearance At Max Lift And Dump 7.63ft in 2323mm
Reach At Max Lift And Dump 22.52in 572mm
Turning Radius From Center - Machine Rear 62.72in 1593mm
Turning Radius From Center - Inc Bucket 74.14in 1883mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.