Specification sheet Skid Steer Loader Ref daewoo-dsl602-skid-steer-loader
Daewoo DSL602
The Daewoo DSL602 is a skid steer loader with an operating weight of 5,412.35 lb (2,455 kg), a 42 hp engine, a rated operating capacity of 1,300.73 lb (590 kg), and a 0.5 yd³ (0.4 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
5,412.35lb
2,455kg
Engine power
42hp
31.4kW
Gross Power Rated operating capacity
1,300.73lb
590kg
Bucket capacity
0.5yd³
0.4m³
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Daewoo DSL602 sits below the median for its class:
- Operating weight 5,410 lb lighter than 81% (n=334)
- Engine power 42 hp less powerful than 87% (n=335)
- Rated operating capacity 1,300 lb lower-rated than 86% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2348 | |
| Engine Model | 4TNE84 | |
| Gross Power | 42hp | 31.4kw |
| Power Measured @ | 2800rpm | |
| Displacement | 121.8cu in | 2L |
02 Operational Specification
| Operational Weight | 5412.4lb | 2455kg |
|---|---|---|
| Fuel Capacity | 13.9gal | 52.4L |
| Max Speed | 6.7mph | 10.7km/h |
| Tire Size | 10 x 16.5 |
03 Loader Specification
| Breakout Force | 2888.1lb | 1310kg |
|---|---|---|
| Operating Load Rating | 1300.8lb | 590kg |
| Bucket Capacity | 0.5yd3 | 0.4m3 |
04 Hydraulic Specification
| Pump Flow Capacity | 11.9gal/min | 44.9L/min |
|---|
05 Dimensions Dimensions
| Length With Bucket | 9.76ft in | 2972mm |
|---|---|---|
| Width Over Tires | 4.88ft in | 1486mm |
| Ground Clearance | 7.49in | 190mm |
| Height To Top Of Cab | 6.35ft in | 1934mm |
| Wheelbase | 3.14ft in | 957mm |
| Length W/O Bucket | 7.54ft in | 2296mm |
| Clearance At Max Lift And Dump | 7.2ft in | 2192mm |
| Reach At Max Lift And Dump | 20.4in | 518mm |
| Turning Radius From Center - Machine Rear | 57.68in | 1465mm |
| Turning Radius From Center - Inc Bucket | 71.03in | 1804mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.