Specification sheet Compact Track Loader Ref caterpillar-247b-ii-multi-terrain-loader

Caterpillar 247B II

The Caterpillar 247B II is a compact track loader with an operating weight of 6,997 lb (3,173.79 kg), a 56 hp engine, a rated operating capacity of 2,050 lb (929.87 kg), and a tipping load of 4,100 lb (1,859.73 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,997lb
3,173.79kg
Engine power
56hp
41.76kW
Net Power
Rated operating capacity
2,050lb
929.87kg
Tipping load
4,100lb † — value reconstructed from related published figures
1,859.73kg

◆Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the Caterpillar 247B II sits below the median for its class:

  • Operating weight 7,000 lb lighter than 84% (n=182)
  • Engine power 56 hp less powerful than 87% (n=167)
  • Rated operating capacity 2,050 lb lower-rated than 75% (n=156)

◇Scale drawingdrawn to scale · mm

1990C267D3285A2518B1499E
Side elevation
1990C1676F
Front elevation

01 Engine Specification

Engine Make 2236
Engine Model C2.2T
Gross Power 61hp 45.5kw
Net Power 56hp 41.8kw
Displacement 134cu in 2.2L

02 Operational Specification

Operating Weight 6997lb 3173.8kg
Cooling System Fluid Capacity 2.7gal 10L
Engine Oil Capacity 2.7gal 10L
Fuel Capacity 17.2gal 65L
Hydraulic System Fluid Capacity 14.6gal 55L
Operating Voltage 12V
Alternator Supplied Amperage 85amps
Max Speed - Low Range 7.6mph 12.2km/h
Max Speed - High Range 7.6mph 12.2km/h

03 Loader Specification

Breakout Force 4060lb 1841.6kg
Operating Load 2050lb 929.9kg

04 Hydraulic Specification

Pump Flow 15.9gal/min 60L/min
Relief Valve Pressure 3335psi 22994kPa

05 Dimensions Dimensions

Width Over Tracks 5.5ft in 1676mm
Height To Top Of Cab 6.53ft in 1990mm
Ground Clearance 10.52in 267mm
Clearance At Max Lift And Dump 7.01ft in 2134mm
Reach At Max Lift And Dump 2.06ft in 625mm
Turning Radius From Center - Machine Rear 53.39in 1356mm
Length With Bucket 10.78ft in 3285mm
Length With Out Bucket 8.27ft in 2518mm
Turning Radius From Center - Inc Bucket 84.93in 2157mm

06 Undercarriage Dimensions

Length Of Track On Ground 4.92ft in 1499mm
Ground Contact Area 1770in2 1.15m2
Ground Pressure 4psi 27.58kPa

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.