Specification sheet Skid Steer Loader Ref caterpillar-226b-skid-steer-loader

Caterpillar 226B

The Caterpillar 226B is a skid steer loader with an operating weight of 5,833.44 lb (2,646 kg), a 57.67 hp engine, a rated operating capacity of 1,499.15 lb (680 kg), and a tipping load of 2,998.3 lb (1,360.01 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,833.44lb
2,646kg
Engine power
57.67hp
43kW
Net Power
Rated operating capacity
1,499.15lb
680kg
Tipping load
2,998.3lb † — value reconstructed from related published figures
1,360.01kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Caterpillar 226B sits below the median for its class:

  • Operating weight 5,830 lb lighter than 71% (n=334)
  • Engine power 58 hp less powerful than 59% (n=335)
  • Rated operating capacity 1,500 lb lower-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

1950C195D3233A2519B
Side elevation
1950C1525E
Front elevation

01 Engine Specification

Engine Make 2236
Engine Model 3024C T
Gross Power 61.7hp 46kw
Net Power 57.7hp 43kw
Aspiration turbocharged

02 Operational Specification

Operational Weight 5833.5lb 2646kg
Fuel Capacity 17.2gal 65L
Cooling System Fluid Capacity 2.7gal 10L
Engine Oil Fluid Capacity 2.2gal 8L
Hydraulic System Fluid Capacity 14.6gal 55L
Max Speed 7.9mph 12.7km/h
Chain Box Fluid Capacity - Each Side 1.6gal 6L
Tire Size 10x16.5 6PR
Operating Voltage 12V
Alternator Supplied Amperage 85amps

03 Loader Specification

Breakout Force 4083lb 1852kg
Operating Load Rating 1499.2lb 680kg

04 Hydraulic Specification

Pump Flow Capacity 15.9gal/min 60L/min
Relief Valve Pressure 3335.9psi 23000kPa

05 Dimensions Dimensions

Length With Bucket 10.61ft in 3233mm
Width Over Tires 5.01ft in 1525mm
Ground Clearance 7.68in 195mm
Height To Top Of Cab 6.4ft in 1950mm
Wheelbase 3.24ft in 986mm
Length W/O Bucket 8.27ft in 2519mm
Clearance At Max Lift And Dump 7.12ft in 2169mm
Reach At Max Lift And Dump 19.89in 505mm
Turning Radius From Center - Machine Rear 58.47in 1485mm
Turning Radius From Center - Inc Bucket 76.38in 1940mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.