Specification sheet Skid Steer Loader Ref case-ih-sv280-skid-steer-loader

Case IH SV280

The Case IH SV280 is a skid steer loader with an operating weight of 8,091 lb (3,670 kg), a 68 hp engine, a rated operating capacity of 2,799.9 lb (1,270 kg), and a tipping load of 5,599.8 lb (2,540.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
8,091lb
3,670kg
Engine power
68hp
50.71kW
Net Power
Rated operating capacity
2,799.9lb
1,270kg
Tipping load
5,599.8lb † — value reconstructed from related published figures
2,540.03kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Case IH SV280 sits above the median for its class:

  • Operating weight 8,090 lb heavier than 81% (n=334)
  • Engine power 68 hp more powerful than 54% (n=335)
  • Rated operating capacity 2,800 lb higher-rated than 88% (n=288)

◇Scale drawingdrawn to scale · mm

2000A1770B
Front elevation

01 Engine Specification

Emissions Certification Tier 4 Final (CEGR, DOC, PM Catalyst)
Engine Model FPT F5H FL463 A*F001
Gross Power 74hp 55.2kw
Net Power 68hp 50.8kw
Engine Peak Torque 231.6lb ft 314Nm
Displacement 207cu in 3.4L

02 Capacities Specification

Rated Operating Capacity 2799.9lb 1270kg

03 Weights Specification

Operating Weight 8091lb 3670kg

04 Lift Specification

Lift Configuration Vertica

05 Hydraulic System Specification

Auxiliary Hydraulic Flow 24.2gal/min 91.7L/min
Optional Auxiliary Hydraulic Pump Flow 37.6gal/min 142.4L/min

06 Bucket Specification

Breakout Force 8767.6lb 39kN

07 Dimensions Dimensions

Width Over Tires 5.81ft in 1770mm
Bucket Hinge Pin Fully Raised 10.83ft in 3.3m
Dump Height - Fully Raised, 45° Dump 100.79in 2560mm
Height To Top Of Rops 78.75in 2000mm
Overall Length (W/Bucket) 12.14ft in 3700mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.