Specification sheet Skid Steer Loader Ref case-ih-sv185-skid-steer-loader

Case IH SV185

The Case IH SV185 is a skid steer loader with an operating weight of 6,569.8 lb (2,980 kg), a 57 hp engine, a rated operating capacity of 1,851.9 lb (840 kg), and a tipping load of 3,699.4 lb (1,678.02 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,569.8lb
2,980kg
Engine power
57hp
42.51kW
Net Power
Rated operating capacity
1,851.9lb
840kg
Tipping load
3,699.4lb † — value reconstructed from related published figures
1,678.02kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Case IH SV185 sits in the middle of its class:

  • Operating weight 6,570 lb lighter than 55% (n=334)
  • Engine power 57 hp less powerful than 61% (n=335)
  • Rated operating capacity 1,850 lb lower-rated than 53% (n=288)

◇Scale drawingdrawn to scale · mm

1970A1640B
Front elevation

01 Engine Specification

Emissions Certification Tier 4 Final (CEGR, DOC)
Engine Model ISM N844LTADI-F-45
Gross Power 60hp 44.8kw
Net Power 57hp 42.6kw
Engine Peak Torque 153lb ft 207.5Nm
Displacement 135.2cu in 2.3L

02 Capacities Specification

Rated Operating Capacity 1851.9lb 840kg

03 Weights Specification

Operating Weight 6569.8lb 2980kg

04 Lift Specification

Lift Configuration Vertical

05 Hydraulic System Specification

Auxiliary Hydraulic Flow 20.6gal/min 78L/min
Optional Auxiliary Hydraulic Pump Flow 30.7gal/min 116.3L/min

06 Bucket Specification

Breakout Force 5552.8lb 24.7kN

07 Dimensions Dimensions

Width Over Tires 5.39ft in 1640mm
Bucket Hinge Pin Fully Raised 10.01ft in 3.05m
Dump Height - Fully Raised, 45° Dump 90.95in 2310mm
Height To Top Of Rops 77.56in 1970mm
Overall Length (W/Bucket) 11.32ft in 3450mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.