Specification sheet Skid Steer Loader Ref case-ih-sr210-skid-steer-loader

Case IH SR210

The Case IH SR210 is a skid steer loader with an operating weight of 6,966.7 lb (3,160 kg), a 68 hp engine, a rated operating capacity of 2,101.1 lb (953 kg), and a tipping load of 4,199.9 lb (1,905.04 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,966.7lb
3,160kg
Engine power
68hp
50.71kW
Net Power
Rated operating capacity
2,101.1lb
953kg
Tipping load
4,199.9lb † — value reconstructed from related published figures
1,905.04kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Case IH SR210 sits in the middle of its class:

  • Operating weight 6,970 lb heavier than 55% (n=334)
  • Engine power 68 hp more powerful than 54% (n=335)
  • Rated operating capacity 2,100 lb higher-rated than 63% (n=288)

◇Scale drawingdrawn to scale · mm

1990A1760B
Front elevation

01 Engine Specification

Emissions Certification Tier 4 Final (CEGR, DOC, PM Catalyst)
Engine Model FPT F5H FL463 A*F001
Gross Power 74hp 55.2kw
Net Power 68hp 50.8kw
Engine Peak Torque 231.6lb ft 314Nm
Displacement 207cu in 3.4L

02 Capacities Specification

Rated Operating Capacity 2101.1lb 953kg

03 Weights Specification

Operating Weight 6966.7lb 3160kg

04 Lift Specification

Lift Configuration Radial

05 Hydraulic System Specification

Auxiliary Hydraulic Flow 24.2gal/min 91.7L/min
Optional Auxiliary Hydraulic Pump Flow 33.2gal/min 125.7L/min

06 Bucket Specification

Breakout Force 7261.4lb 32.3kN

07 Dimensions Dimensions

Width Over Tires 5.78ft in 1760mm
Bucket Hinge Pin Fully Raised 10.24ft in 3.12m
Dump Height - Fully Raised, 45° Dump 95.67in 2430mm
Height To Top Of Rops 78.35in 1990mm
Overall Length (W/Bucket) 11.16ft in 3400mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.