Specification sheet Skid Steer Loader Ref case-ih-sr175-skid-steer-loader

Case IH SR175

The Case IH SR175 is a skid steer loader with an operating weight of 6,265.6 lb (2,842 kg), a 64 hp engine, a rated operating capacity of 1,741.7 lb (790 kg), and a tipping load of 3,501 lb (1,588.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,265.6lb
2,842kg
Engine power
64hp
47.73kW
Net Power
Rated operating capacity
1,741.7lb
790kg
Tipping load
3,501lb † — value reconstructed from related published figures
1,588.03kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Case IH SR175 sits below the median for its class:

  • Operating weight 6,270 lb lighter than 62% (n=334)
  • Engine power 64 hp more powerful than 51% (n=335)
  • Rated operating capacity 1,740 lb lower-rated than 62% (n=288)

◇Scale drawingdrawn to scale · mm

1970A1640B
Front elevation

01 Engine Specification

Emissions Certification Tier 4 Final (CEGR, DOC)
Engine Model ISM N844LTADI-F-50
Gross Power 67hp 50kw
Net Power 64hp 47.8kw
Engine Peak Torque 153lb ft 207.5Nm
Displacement 135.2cu in 2.3L

02 Capacities Specification

Rated Operating Capacity 1741.7lb 790kg

03 Weights Specification

Operating Weight 6265.6lb 2842kg

04 Lift Specification

Lift Configuration Radial

05 Hydraulic System Specification

Auxiliary Hydraulic Flow 20.6gal/min 78L/min
Optional Auxiliary Hydraulic Pump Flow 30.7gal/min 116.3L/min

06 Bucket Specification

Breakout Force 7261.4lb 32.3kN

07 Dimensions Dimensions

Width Over Tires 5.39ft in 1640mm
Bucket Hinge Pin Fully Raised 10.18ft in 3.1m
Dump Height - Fully Raised, 45° Dump 94.49in 2400mm
Height To Top Of Rops 77.56in 1970mm
Overall Length (W/Bucket) 11.19ft in 3410mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.