Specification sheet Skid Steer Loader Ref case-ih-sr130-skid-steer-loader

Case IH SR130

The Case IH SR130 is a skid steer loader with an operating weight of 5,070.7 lb (2,300 kg), a 45.8 hp engine, a rated operating capacity of 1,300.73 lb (590 kg), and a tipping load of 2,599.3 lb (1,179.02 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,070.7lb
2,300kg
Engine power
45.8hp
34.16kW
Net Power
Rated operating capacity
1,300.73lb
590kg
Tipping load
2,599.3lb † — value reconstructed from related published figures
1,179.02kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Case IH SR130 sits at the compact end of its class:

  • Operating weight 5,070 lb lighter than 86% (n=334)
  • Engine power 46 hp less powerful than 82% (n=335)
  • Rated operating capacity 1,300 lb lower-rated than 86% (n=288)

◇Scale drawingdrawn to scale · mm

1920A1520B
Front elevation

01 Engine Specification

Emissions Certification Tier 4 Final (DOC, DPF)
Engine Model ISM N844L-F
Gross Power 48.8hp 36.4kw
Net Power 45.8hp 34.2kw
Engine Peak Torque 105.5lb ft 143Nm
Displacement 135.2cu in 2.3L

02 Capacities Specification

Rated Operating Capacity 1300.8lb 590kg

03 Loader Specification

Operating Load Rating 1300.8lb 590kg

04 Weights Specification

Operating Weight 5070.7lb 2300kg

05 Lift Specification

Lift Configuration Radial

06 Hydraulic System Specification

Auxiliary Hydraulic Flow 17.5gal/min 66.3L/min

07 Bucket Specification

Breakout Force 4181.5lb 18.6kN

08 Dimensions Dimensions

Width Over Tires 4.99ft in 1520mm
Bucket Hinge Pin Fully Raised 9.36ft in 2.85m
Dump Height - Fully Raised, 45° Dump 84.65in 2150mm
Height To Top Of Rops 75.6in 1920mm
Overall Length (W/Bucket) 10.44ft in 3180mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.