Specification sheet Wheel Loader Ref case-921f-wheel-loader
Case 921F
The Case 921F is a wheel loader with an operating weight of 43,777 lb (19,856.92 kg), a 225 hp engine, and a 4.7 yd³ (3.6 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
43,777lb
19,856.92kg
Engine power
225hp
167.8kW
Net Power Bucket capacity
4.7yd³
3.6m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Case 921F sits at the heavy end of its class:
- Operating weight 43,780 lb heavier than 97% (n=439)
- Engine power 225 hp more powerful than 92% (n=408)
- Bucket capacity 4.7 yd³ larger-bucket than 94% (n=387)
◇Scale drawingdrawn to scale · mm
01 Hydraulic Cycle Times (Unloaded) Specification
| Total Cycle Time | 10.7sec |
|---|
02 Engine Specification
| Emissions Level | Tier 4 | |
|---|---|---|
| Engine Speed - Rated Speed, Full Load | 2000rpm | |
| Number Of Cylinders | 6 | |
| Max. Torque Iso14396 | 958.9lb ft | 1300Nm |
| Engine Model | FPT F4HFE613 | |
| Net Power | 225hp | 167.8kw |
| Gross Power | 255hp | 190.2kw |
| Power Measured @ | 1600rpm | |
| Max Torque | 959lb ft | 1300.3Nm |
| Displacement | 411cu in | 6.8L |
| Torque Measured @ | 1300rpm | |
| Aspiration | Turbocharged | |
| Torque Rise | 49% | |
| Alternator | 120amps |
03 Operational Specification
| Operating Weight | 43777lb | 19857kg |
|---|---|---|
| Fuel Capacity | 76.1gal | 288.1L |
| Hydraulic System Fluid Capacity | 53gal | 200.7L |
| Engine Oil Fluid Capacity | 4gal | 15.1L |
| Cooling System Fluid Capacity | 8gal | 30L |
| Transmission Fluid Capacity | 9.1gal | 34.1L |
| Static Tipping Weight | 31405lb | 14245.1kg |
| Turning Radius | 19.8ft in | 6032mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 65amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 23.5 25 L3 |
04 Transmission Specification
| Differential Lock | F: LSD / R: LSD | |
|---|---|---|
| Transmission Type | Powershift | |
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 22.4mph | 36.1km/h |
| Max Speed - Reverse | 15mph | 24.2km/h |
05 Hydraulic System Specification
| Steering Pump Type | Articulation | |
|---|---|---|
| Maximum System Pressure | 3625psi | 24993.5kPa |
| Relief Valve Setting | 3625psi | 24993.5kPa |
| Pump Flow Capacity | 42.8gal/min | 162L/min |
| Raise Time | 6.2sec | |
| Dump Time | 1.4sec | |
| Lower Time | 3.1sec | |
| Pump Type | Axial Piston Pump |
06 Brakes Specification
| Service Brake | Wet Multi Disc |
|---|
07 Bucket Dimensions
| Dump Clearance At Max Raise | 9.54ft in | 2906mm |
|---|---|---|
| Breakout Force | 37543.1lb | 167kN |
| Bucket Capacity - Heaped | 4.7yd3 | 3.6m3 |
| Bucket Capacity - Struck | 4.08yd3 | 3.12m3 |
| Bucket Width | 9.95ft in | 3030mm |
08 Dimensions Dimensions
| Ground Clearance | 1.37ft in | 415mm |
|---|---|---|
| Length With Bucket On Ground | 26.17ft in | 7976mm |
| Width Over Tires | 9.47ft in | 2885mm |
| Height To Top Of Cab | 11.32ft in | 3450mm |
| Wheelbase | 10.96ft in | 3340mm |
| Hinge Pin - Max Height | 13.52ft in | 4118mm |
| Reach At Max Lift And Dump | 5.75ft in | 1752mm |
| Dump Reach @ Full Height, 45° Dump: Bucket | 3.92ft in | 1.2m |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.