Specification sheet Wheel Loader Ref case-921e-wheel-loader
Case 921E
The Case 921E is a wheel loader with an operating weight of 50,622 lb (22,962 kg), a 297 hp engine, and a 5.78 yd³ (4.42 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
50,622lb
22,962kg
Engine power
297hp
221kW
Net Power Bucket capacity
5.78yd³
4.42m³
◆Where it sits in its classpercentile · medium wheel loaders
Among 198 medium wheel loaders (45,000–90,000 lb), the Case 921E sits below the median for its class:
- Operating weight 50,620 lb lighter than 71% (n=198)
- Engine power 297 hp more powerful than 65% (n=190)
- Bucket capacity 5.8 yd³ larger-bucket than 59% (n=174)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2347 | |
| Engine Model | QSM 11, Tier III Certified | |
| Net Power | 297hp | 221kw |
| Gross Power | 274hp | 204kw |
| Power Measured @ | 1800rpm | |
| Max Torque | 1013lb ft | 1373Nm |
| Displacement | 660cu in | 10.8L |
| Torque Measured @ | 900rpm | |
| Aspiration | Turbocharged with Aftercooler |
02 Operational Specification
| Operating Weight | 50622lb | 22962kg |
|---|---|---|
| Fuel Capacity | 104gal | 393.7L |
| Hydraulic System Fluid Capacity | 64gal | 242L |
| Engine Oil Fluid Capacity | 9.8gal | 36.9L |
| Cooling System Fluid Capacity | 15gal | 56.8L |
| Transmission Fluid Capacity | 10.5gal | 39.7L |
| Front Axle/Diff Fluid Capacity | 12.5gal | 47.3L |
| Rear Axle/Diff Fluid Capacity | 12.5gal | 47.3L |
| Static Tipping Weight | 42592lb | 19319kg |
| Turning Radius | 22.6ft in | 6870mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 95amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 26.5 x 25 L3 Bias |
03 Transmission Specification
| Transmission Type | 4F/3R Proportional w/Electronic Control Module | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 23.2mph | 37.4km/h |
| Max Speed - Reverse | 16.1mph | 25.8km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3600psi | 24821kPa |
|---|---|---|
| Pump Flow Capacity | 42.8gal/min | 162.1L/min |
| Raise Time | 6.2sec | |
| Dump Time | 3.6sec | |
| Lower Time | 3sec | |
| Pump Type | closed centered pressure/flow compensated |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 10.09ft in | 3080mm |
|---|---|---|
| Bucket Capacity - Heaped | 5.78yd3 | 4.42m3 |
| Bucket Capacity - Struck | 4.88yd3 | 3.74m3 |
| Bucket Width | 10.4ft in | 3170mm |
| Breakout Force | 44476lb | 197.84kN |
06 Dimensions Dimensions
| Ground Clearance | 1.6ft in | 487.68mm |
|---|---|---|
| Length With Bucket On Ground | 28.88ft in | 8800mm |
| Width Over Tires | 9.81ft in | 2987mm |
| Height To Top Of Cab | 12.12ft in | 3700mm |
| Wheelbase | 11.17ft in | 3400mm |
| Hinge Pin - Max Height | 14.03ft in | 4280mm |
| Reach At Max Lift And Dump | 4.17ft in | 1270mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.