Specification sheet Wheel Loader Ref case-721cxt-wheel-loader
Case 721CXT
The Case 721CXT is a wheel loader with an operating weight of 29,856 lb (13,542.46 kg), a 152 hp engine, and a 2.5 yd³ (1.91 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
29,856lb
13,542.46kg
Engine power
152hp
113.4kW
Net Power Bucket capacity
2.5yd³
1.91m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Case 721CXT sits in the middle of its class:
- Operating weight 29,860 lb lighter than 55% (n=439)
- Engine power 152 hp less powerful than 62% (n=408)
- Bucket capacity 2.5 yd³ smaller-bucket than 81% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2239 | |
| Engine Model | 6T-830 | |
| Net Power | 152hp | 113.4kw |
| Gross Power | 165hp | 123.1kw |
| Power Measured @ | 2200rpm | |
| Max Torque | 545lb ft | 739Nm |
| Displacement | 504cu in | 8.3L |
| Torque Measured @ | 1300rpm | |
| Aspiration | turbocharged | |
| Torque Rise | 41% |
02 Operational Specification
| Operating Weight | 29856lb | 13542.5kg |
|---|---|---|
| Fuel Capacity | 53.9gal | 204L |
| Hydraulic System Fluid Capacity | 40.5gal | 153.3L |
| Engine Oil Fluid Capacity | 5.5gal | 20.8L |
| Cooling System Fluid Capacity | 8.6gal | 32.2L |
| Transmission Fluid Capacity | 3.3gal | 12.3L |
| Front Axle/Diff Fluid Capacity | 7.1gal | 26.5L |
| Rear Axle/Diff Fluid Capacity | 5.5gal | 20.8L |
| Static Tipping Weight | 21751lb | 9866kg |
| Turning Radius | 17.3ft in | 5250mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 65amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 20.5-25 L3 |
03 Transmission Specification
| Transmission Type | 4F/3R proportional w/ electronic control module torque sensing autoshift/manual shift and modulation | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 24.2mph | 39km/h |
| Max Speed - Reverse | 17.1mph | 27.6km/h |
04 Hydraulic System Specification
| Pump Flow Capacity | 18.6gal/min | 70.5L/min |
|---|---|---|
| Raise Time | 5.4sec | |
| Dump Time | 2sec | |
| Lower Time | 4.6sec | |
| Pump Type | dual, vane-type tandem |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.42ft in | 2870mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.5yd3 | 1.91m3 |
| Bucket Capacity - Struck | 2.15yd3 | 1.64m3 |
| Bucket Width | 8.6ft in | 2620mm |
| Breakout Force | 28097lb | 124.99kN |
06 Dimensions Dimensions
| Ground Clearance | 1.38ft in | 419mm |
|---|---|---|
| Length With Bucket On Ground | 23.86ft in | 7270mm |
| Width Over Tires | 8.31ft in | 2530mm |
| Height To Top Of Cab | 10.7ft in | 3260mm |
| Wheelbase | 9.52ft in | 2900mm |
| Hinge Pin - Max Height | 12.67ft in | 3860mm |
| Reach At Max Lift And Dump | 3.84ft in | 1170mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.