Specification sheet Wheel Loader Ref case-621cxr-wheel-loader
Case 621CXR
The Case 621CXR is a wheel loader with an operating weight of 27,091 lb (12,288.28 kg), a 130 hp engine, and a 2.32 yd³ (1.77 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
27,091lb
12,288.28kg
Engine power
130hp
97kW
Net Power Bucket capacity
2.32yd³
1.77m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Case 621CXR sits below the median for its class:
- Operating weight 27,090 lb lighter than 73% (n=439)
- Engine power 130 hp less powerful than 84% (n=408)
- Bucket capacity 2.3 yd³ smaller-bucket than 88% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 6 | |
|---|---|---|
| Engine Make | 2239 | |
| Engine Model | 6T-590 | |
| Net Power | 130hp | 97kw |
| Gross Power | 139hp | 103.7kw |
| Power Measured @ | 2000rpm | |
| Max Torque | 413lb ft | 560Nm |
| Displacement | 359cu in | 5.9L |
| Torque Measured @ | 1400rpm | |
| Aspiration | turbocharged | |
| Torque Rise | 31% |
02 Operational Specification
| Operating Weight | 27091lb | 12288.3kg |
|---|---|---|
| Fuel Capacity | 51gal | 193L |
| Hydraulic System Fluid Capacity | 40.5gal | 153.3L |
| Engine Oil Fluid Capacity | 4gal | 15.1L |
| Cooling System Fluid Capacity | 7.1gal | 26.5L |
| Transmission Fluid Capacity | 2gal | 7.4L |
| Front Axle/Diff Fluid Capacity | 5.5gal | 20.8L |
| Rear Axle/Diff Fluid Capacity | 5.5gal | 20.8L |
| Static Tipping Weight | 18479.2lb | 8382kg |
| Turning Radius | 17.1ft in | 5190mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 65amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 20.5-25 L3 |
03 Transmission Specification
| Transmission Type | 4F/3R proportional w/ electronic control module torque sensing autoshift/manual shift and modulation | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 23.3mph | 37.5km/h |
| Max Speed - Reverse | 15.5mph | 25km/h |
04 Hydraulic System Specification
| Pump Flow Capacity | 18.6gal/min | 70.5L/min |
|---|---|---|
| Raise Time | 5.4sec | |
| Dump Time | 1.5sec | |
| Lower Time | 5sec | |
| Pump Type | dual, vane-type tandem |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 10.47ft in | 3190mm |
|---|---|---|
| Bucket Capacity - Heaped | 2.32yd3 | 1.77m3 |
| Bucket Capacity - Struck | 1.98yd3 | 1.51m3 |
| Bucket Width | 8.34ft in | 2540mm |
| Breakout Force | 25002lb | 25002- |
06 Dimensions Dimensions
| Ground Clearance | 1.4ft in | 425mm |
|---|---|---|
| Length With Bucket On Ground | 22.97ft in | 7000mm |
| Width Over Tires | 7.98ft in | 2430mm |
| Height To Top Of Cab | 10.7ft in | 3260mm |
| Wheelbase | 9.52ft in | 2900mm |
| Hinge Pin - Max Height | 13.06ft in | 3980mm |
| Reach At Max Lift And Dump | 3ft in | 914mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.