Specification sheet Wheel Loader Ref case-521dxt-wheel-loader
Case 521DXT
The Case 521DXT is a wheel loader with an operating weight of 23,938 lb (10,858.1 kg), a 110 hp engine, and a 2 yd³ (1.53 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
23,938lb
10,858.1kg
Engine power
110hp
82kW
Net Power Bucket capacity
2yd³
1.53m³
◆Where it sits in its classpercentile · small wheel loaders
Among 439 small wheel loaders (22,000–45,000 lb), the Case 521DXT sits at the compact end of its class:
- Operating weight 23,940 lb lighter than 89% (n=439)
- Engine power 110 hp less powerful than 99% (n=408)
- Bucket capacity 2 yd³ smaller-bucket than 96% (n=387)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2239 | |
| Engine Model | Family III 445TA/M2, Tier II certified | |
| Net Power | 110hp | 82kw |
| Gross Power | 119hp | 89kw |
| Power Measured @ | 2000rpm | |
| Max Torque | 336lb ft | 455Nm |
| Displacement | 275cu in | 4.5L |
| Torque Measured @ | 1400rpm | |
| Aspiration | Turbocharged and Aftercooled | |
| Torque Rise | 14% |
02 Operational Specification
| Operating Weight | 23938lb | 10858.1kg |
|---|---|---|
| Fuel Capacity | 50gal | 189L |
| Hydraulic System Fluid Capacity | 30gal | 113.6L |
| Engine Oil Fluid Capacity | 3.4gal | 12.5L |
| Cooling System Fluid Capacity | 5.8gal | 22L |
| Transmission Fluid Capacity | 5gal | 18.9L |
| Front Axle/Diff Fluid Capacity | 5.9gal | 22L |
| Rear Axle/Diff Fluid Capacity | 5.9gal | 22L |
| Static Tipping Weight | 18424lb | 8357kg |
| Turning Radius | 16.3ft in | 4947mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 70amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 17.5x25 |
03 Transmission Specification
| Transmission Type | 4F/3R Proportional w/ Electronic Control Module torque sensing autoshift/manual shift and modulation | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 23.4mph | 37.6km/h |
| Max Speed - Reverse | 15.2mph | 24.5km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 2750psi | 18961kPa |
|---|---|---|
| Pump Flow Capacity | 35.4gal/min | 134L/min |
| Raise Time | 5.6sec | |
| Dump Time | 1.1sec | |
| Lower Time | 3.7sec | |
| Pump Type | closed centered pressure/flow compensated |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 9.06ft in | 2757mm |
|---|---|---|
| Bucket Capacity - Heaped | 2yd3 | 1.53m3 |
| Bucket Width | 8.1ft in | 2468mm |
| Breakout Force | 21929lb | 97.55kN |
06 Dimensions Dimensions
| Ground Clearance | 1.24ft in | 377mm |
|---|---|---|
| Length With Bucket On Ground | 22.04ft in | 6715mm |
| Width Over Tires | 7.58ft in | 2308mm |
| Height To Top Of Cab | 10.41ft in | 3173mm |
| Wheelbase | 9.03ft in | 2750mm |
| Hinge Pin - Max Height | 12.27ft in | 3739mm |
| Reach At Max Lift And Dump | 3.69ft in | 1122mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.