Specification sheet Wheel Loader Ref case-221e-wheel-loader
Case 221E
The Case 221E is a wheel loader with an operating weight of 11,947 lb (5,419 kg), a 59 hp engine, and a 1.31 yd³ (1.01 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
11,947lb
5,419kg
Engine power
59hp
43kW
Net Power Bucket capacity
1.31yd³
1.01m³
◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Case 221E sits in the middle of its class:
- Operating weight 11,950 lb lighter than 55% (n=374)
- Engine power 59 hp less powerful than 68% (n=367)
- Bucket capacity 1.3 yd³ smaller-bucket than 56% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2349 | |
| Engine Model | F4M2011, Tier 2 certified | |
| Net Power | 59hp | 43kw |
| Gross Power | 60hp | 45kw |
| Power Measured @ | 2500rpm | |
| Max Torque | 131lb ft | 178Nm |
| Displacement | 190cu in | 3.2L |
| Torque Measured @ | 1700rpm |
02 Operational Specification
| Operating Weight | 11947lb | 5419kg |
|---|---|---|
| Fuel Capacity | 26gal | 100L |
| Hydraulic System Fluid Capacity | 17.7gal | 67L |
| Engine Oil Fluid Capacity | 2.7gal | 10L |
| Front Axle/Diff Fluid Capacity | 2.1gal | 8L |
| Rear Axle/Diff Fluid Capacity | 2.1gal | 8L |
| Static Tipping Weight | 9358lb | 4245kg |
| Turning Radius | 13.5ft in | 4095mm |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 55amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 365/80 R20 EM SPT9 |
03 Transmission Specification
| Transmission Type | Hydrostatic transmission | |
|---|---|---|
| Number Of Forward Gears | 2 | |
| Number Of Reverse Gears | 2 | |
| Max Speed - Forward | 12.4mph | 20km/h |
| Max Speed - Reverse | 12.4mph | 20km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3626psi | 23000kPa |
|---|---|---|
| Pump Flow Capacity | 18.5gal/min | 70L/min |
| Raise Time | 6sec | |
| Dump Time | 1sec | |
| Lower Time | 3sec | |
| Pump Type | Open-centered pressure/flow compensated |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.53ft in | 2598mm |
|---|---|---|
| Bucket Capacity - Heaped | 1.31yd3 | 1.01m3 |
| Bucket Capacity - Struck | 1.1yd3 | 0.84m3 |
| Bucket Width | 6.89ft in | 2100mm |
| Breakout Force | 9723lb | 4410kN |
06 Dimensions Dimensions
| Ground Clearance | 1.08ft in | 330mm |
|---|---|---|
| Length With Bucket On Ground | 18.49ft in | 5635mm |
| Width Over Tires | 6.25ft in | 1904mm |
| Height To Top Of Cab | 9.17ft in | 2793mm |
| Wheelbase | 7.71ft in | 2350mm |
| Hinge Pin - Max Height | 11.11ft in | 3386mm |
| Reach At Max Lift And Dump | 2.85ft in | 867mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.