Case 21E
The Case 21E is a wheel loader with an operating weight of 10,168 lb (4,612 kg), a 52 hp engine, and a 1.05 yd³ (0.81 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →◆Where it sits in its classpercentile · compact wheel loaders
Among 374 compact wheel loaders (≤22,000 lb), the Case 21E sits below the median for its class:
- Operating weight 10,170 lb lighter than 73% (n=374)
- Engine power 52 hp less powerful than 77% (n=367)
- Bucket capacity 1.1 yd³ smaller-bucket than 76% (n=309)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2239 | |
| Engine Model | 432T/M3 | |
| Net Power | 52hp | 38kw |
| Gross Power | 54.2hp | 40.4kw |
| Power Measured @ | 2300rpm | |
| Max Torque | 125lb ft | 169Nm |
| Displacement | 190cu in | 3.2L |
| Torque Measured @ | 1700rpm |
02 Operational Specification
| Operating Weight | 10168lb | 4612kg |
|---|---|---|
| Fuel Capacity | 26.4gal | 100L |
| Hydraulic System Fluid Capacity | 14.8gal | 56L |
| Engine Oil Fluid Capacity | 2.6gal | 10L |
| Front Axle/Diff Fluid Capacity | 2gal | 7.5L |
| Rear Axle/Diff Fluid Capacity | 2gal | 7.5L |
| Static Tipping Weight | 7342lb | 3330kg |
| Turning Radius | 12.7ft in | 3847mm |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 55amps | |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 365/80 R20 |
03 Transmission Specification
| Transmission Type | Hydrostatic transmission | |
|---|---|---|
| Number Of Forward Gears | 2 | |
| Number Of Reverse Gears | 2 | |
| Max Speed - Forward | 12.4mph | 20km/h |
| Max Speed - Reverse | 12.4mph | 20km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3625psi | 25000kPa |
|---|---|---|
| Pump Flow Capacity | 13.5gal/min | 51L/min |
| Raise Time | 6sec | |
| Dump Time | 1sec | |
| Lower Time | 3sec | |
| Pump Type | Open-centered pressure/flow compensated |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.22ft in | 2502mm |
|---|---|---|
| Bucket Capacity - Heaped | 1.05yd3 | 0.81m3 |
| Bucket Capacity - Struck | 0.92yd3 | 0.71m3 |
| Bucket Width | 6.23ft in | 1900mm |
| Breakout Force | 7801lb | _- |
06 Dimensions Dimensions
| Ground Clearance ‡ — value corrected — the source published it under the wrong unit | 1.08ft in | 330mm |
|---|---|---|
| Length With Bucket On Ground | 17.45ft in | 5315mm |
| Width Over Tires | 6.09ft in | 1857mm |
| Height To Top Of Cab | 8.83ft in | 2690mm |
| Wheelbase | 7.16ft in | 2182mm |
| Hinge Pin - Max Height | 10.67ft in | 3252mm |
| Reach At Max Lift And Dump | 2.8ft in | 851mm |
Data notes
Corrected value. The source published this figure under the wrong unit. The metric figure is authoritative and the imperial value shown here is derived from it.
- Ground Clearance: shown as 1.08 ft in (source stated a value inconsistent with its own metric figure of 330 mm)
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.