Specification sheet Skid Steer Loader Ref case-1825b-skid-steer-loader
Case 1825B
The Case 1825B is a skid steer loader with an operating weight of 3,106.32 lb (1,409 kg), a 27 hp engine, and a rated operating capacity of 884.06 lb (401 kg).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
3,106.32lb
1,409kg
Engine power
27hp
20.14kW
Net Power Rated operating capacity
884.06lb
401kg
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Case 1825B sits at the compact end of its class:
- Operating weight 3,110 lb lighter than 94% (n=334)
- Engine power 27 hp less powerful than 94% (n=335)
- Rated operating capacity 880 lb lower-rated than 93% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | Kubota | |
| Engine Model | V1505 | |
| Gross Power | 30hp | 22.4kw |
| Net Power | 27hp | 20.2kw |
| Power Measured @ | 2400rpm | |
| Max Torque | 67.2lb ft | 91Nm |
| Torque Measured @ | 2100rpm | |
| Displacement | 91.6cu in | 1.5L |
| Bore | 3.1in | 78mm |
| Stroke | 3.1in | 78.4mm |
02 Operational Specification
| Operational Weight | 3106.4lb | 1409kg |
|---|---|---|
| Fuel Capacity | 8.6gal | 32.2L |
| Engine Oil Fluid Capacity | 1.7gal | 6.3L |
| Hydraulic System Fluid Capacity | 5.8gal | 21.8L |
| Max Speed | 5.8mph | 9.2km/h |
| Chain Box Fluid Capacity - Each Side | 0.8gal | 2.8L |
| Tire Size | 5.70 x 15, 4PR | |
| Operating Voltage | 12V | |
| Alternator Supplied Amperage | 30amps |
03 Loader Specification
| Operating Load Rating | 884.1lb | 401kg |
|---|---|---|
| Bucket Width | 48.9in | 1240mm |
04 Hydraulic Specification
| Pump Type | Gear pump driven directl | |
|---|---|---|
| Pump Flow Capacity | 9.6gal/min | 36.3L/min |
| Relief Valve Pressure | 2300psi | 15858kPa |
| Raise Time | 4.1sec | |
| Dump Time | 1.2sec | |
| Lower Time | 2.5sec |
05 Dimensions Dimensions
| Width Over Tires | 3.25ft in | 990mm |
|---|---|---|
| Ground Clearance | 6.7in | 170mm |
| Wheelbase | 2.79ft in | 850mm |
| Length W/O Bucket | 9.09ft in | 2770mm |
| Hinge Pin Height - Fully Raised | 98.04in | 2490mm |
| Height To Top Of Rops | 70.08in | 1780mm |
| Angle Of Departure | 31degrees |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.