Specification sheet Compact Track Loader Ref bobcat-t650-multi-terrain-loader

Bobcat T650

The Bobcat T650 is a compact track loader with an operating weight of 9,113 lb (4,133.59 kg), a 74.3 hp engine, a rated operating capacity of 3,670 lb (1,664.69 kg), and a tipping load of 7,343 lb (3,330.73 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
9,113lb
4,133.59kg
Engine power
74.3hp
55.5kW
Gross Power
Rated operating capacity
3,670lb
1,664.69kg

Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the Bobcat T650 sits in the middle of its class:

  • Operating weight 9,110 lb lighter than 56% (n=182)
  • Engine power 74 hp more powerful than 59% (n=167)
  • Rated operating capacity 3,670 lb higher-rated than 83% (n=156)

Scale drawingdrawn to scale · mm

2065C3475A2753B1486D
Side elevation
2065C1853E
Front elevation

01 Engine Specification

Fuel Diesel
Emission Tier Level Tier 4
Horsepower - Gross 74hp 55.2kw
Gross Power 74.3hp 55.5kw
Aspiration Turbocharged

02 Operational Specification

Operating Weight 9113lb 4133.6kg
Cooling System Fluid Capacity 3gal 11.4L
Fuel Capacity 43.9gal 166.2L
Max Speed - Low Range 6.6mph 10.7km/h
Travel Speed 6.2mph 10km/h

03 Loader Specification

Operating Load 3670lb 1664.7kg

04 Hydraulic Specification

Pump Flow 23gal/min 87.1L/min
Relief Valve Pressure 3500psi 24131.7kPa

05 Dimensions Dimensions

Width Over Tracks 6.08ft in 1853.19mm
Height To Top Of Cab 6.78ft in 2065.02mm
Reach At Max Lift And Dump 2.85ft in 868.68mm
Overall Width 6.08ft in 1851.66mm
Overall Height 6.78ft in 2065.02mm
Length With Bucket 11.4ft in 3474.72mm
Length With Out Bucket 9.04ft in 2753.36mm
Turning Radius From Center - Machine Rear 87.7in 2227.58mm

06 Undercarriage Dimensions

Length Of Track On Ground 4.88ft in 1485.9mm
Width Of Track 12.6in 320.05mm
Ground Pressure 5.7psi 39.31kPa

Data notes

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.