Specification sheet Skid Steer Loader Ref bobcat-s740-skid-steer-loader

Bobcat S740

The Bobcat S740 is a skid steer loader with an operating weight of 2,795 lb (1,267.8 kg), a 23.5 hp engine, a rated operating capacity of 700 lb (317.52 kg), and a tipping load of 1,512 lb (685.83 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
2,795lb
1,267.8kg
Engine power
23.5hp
17.6kW
Gross Power
Rated operating capacity
700lb
317.52kg
Tipping load
1,512lb † — value reconstructed from related published figures
685.83kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S740 sits at the compact end of its class:

  • Operating weight 2,800 lb lighter than 96% (n=334)
  • Engine power 24 hp less powerful than 96% (n=335)
  • Rated operating capacity 700 lb lower-rated than 97% (n=288)

◇Scale drawingdrawn to scale · mm

1814C152A152B
Side elevation
1814C902D
Front elevation

01 Engine Specification

Emission Tier Level Tier 4
Gross Power 23.5hp 17.6kw
Cooling System Liquid
Aspiration Turbocharged
Fuel Type Turbo Diesel

02 Operational Specification

Lift Arm Path Vertical
Operational Weight 2795lb 1267.8kg
Fuel Capacity 24.7gal 93.5L
Max Speed 7.4mph 12km/h

03 Loader Specification

Loader Series M2-Series
Height To Hinge Pin 10ft in 3023mm
Operating Load Rating 700lb 317.6kg
Bucket Width 68in 1727mm

04 Hydraulic Specification

Main Pump Flow Standard 9.8gal/min 37.1L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Length With Bucket 0.5ft in 152.4mm
Width Over Tires 2.96ft in 901.7mm
Height To Top Of Cab 5.95ft in 1813.56mm
Wheelbase 2.37ft in 721.36mm
Length W/O Bucket 0.5ft in 152.4mm
Clearance At Max Lift And Dump 1.32ft in 401.32mm
Reach At Max Lift And Dump 32.6in 828mm
Turning Radius From Center - Inc Bucket 58.7in 1490.98mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.