Specification sheet Skid Steer Loader Ref bobcat-s590-skid-steer-loader

Bobcat S590

The Bobcat S590 is a skid steer loader with an operating weight of 6,594.03 lb (2,991 kg), a 66 hp engine, a rated operating capacity of 2,100 lb (952.55 kg), and a tipping load of 4,199.9 lb (1,905.04 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,594.03lb
2,991kg
Engine power
66hp
49.3kW
Gross Power
Rated operating capacity
2,100lb
952.55kg
Tipping load
4,199.9lb † — value reconstructed from related published figures
1,905.04kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S590 sits in the middle of its class:

  • Operating weight 6,590 lb lighter than 55% (n=334)
  • Engine power 66 hp more powerful than 53% (n=335)
  • Rated operating capacity 2,100 lb higher-rated than 62% (n=288)

◇Scale drawingdrawn to scale · mm

1972C185D3378A2657B
Side elevation
1972C1656E
Front elevation

01 Engine Specification

Emission Tier Level Tier 4
Gross Power 66hp 49.3kw
Cooling System Liquid
Aspiration Turbocharged
Fuel Type Turbo Diesel

02 Operational Specification

Lift Arm Path Vertical
Operational Weight 6594.1lb 2991kg
Fuel Capacity 24.7gal 93.5L
Max Speed 7.4mph 12km/h

03 Loader Specification

Loader Series M2-Series
Height To Hinge Pin 10ft in 3023mm
Operating Load Rating 2100lb 952.6kg
Bucket Width 68in 1727mm

04 Hydraulic Specification

Main Pump Flow Standard 17.1gal/min 64.8L/min
Main Pump Flow Optional 26.7gal/min 101.1L/min
Relief Valve Pressure 3500psi 24131.7kPa

05 Dimensions Dimensions

Length With Bucket 11.09ft in 3378mm
Width Over Tires 5.44ft in 1656mm
Ground Clearance 7.29in 185mm
Height To Top Of Cab 6.47ft in 1972mm
Wheelbase 3.55ft in 1082mm
Length W/O Bucket 8.72ft in 2657mm
Clearance At Max Lift And Dump 7.61ft in 2319mm
Reach At Max Lift And Dump 32.6in 828mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.