Specification sheet Skid Steer Loader Ref bobcat-s550-skid-steer-loader

Bobcat S550

The Bobcat S550 is a skid steer loader with an operating weight of 6,212.63 lb (2,818 kg), a 61 hp engine, a rated operating capacity of 1,750 lb (793.79 kg), and a tipping load of 3,501 lb (1,588.03 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,212.63lb
2,818kg
Engine power
61hp
45.5kW
Gross Power
Rated operating capacity
1,750lb
793.79kg
Tipping load
3,501lb † — value reconstructed from related published figures
1,588.03kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S550 sits below the median for its class:

  • Operating weight 6,210 lb lighter than 64% (n=334)
  • Engine power 61 hp less powerful than 52% (n=335)
  • Rated operating capacity 1,750 lb lower-rated than 61% (n=288)

◇Scale drawingdrawn to scale · mm

1972C185D3378A2657B
Side elevation
1972C1643E
Front elevation

01 Engine Specification

Emission Tier Level Tier 4
Gross Power 61hp 45.5kw
Cooling System Liquid
Aspiration Turbocharged
Fuel Type Turbo Diesel

02 Operational Specification

Lift Arm Path Radius
Operational Weight 6212.7lb 2818kg
Fuel Capacity 24.7gal 93.5L
Max Speed 7.4mph 12km/h

03 Loader Specification

Loader Series M2-Series
Height To Hinge Pin 9.6ft in 2908mm
Operating Load Rating 1750lb 793.8kg
Bucket Width 68in 1727mm

04 Hydraulic Specification

Main Pump Flow Standard 17.1gal/min 64.8L/min
Main Pump Flow Optional 26.7gal/min 101.1L/min
Relief Valve Pressure 3500psi 24131.7kPa

05 Dimensions Dimensions

Length With Bucket 11.09ft in 3378mm
Width Over Tires 5.4ft in 1643mm
Ground Clearance 7.29in 185mm
Height To Top Of Cab 6.47ft in 1972mm
Wheelbase 3.55ft in 1082mm
Length W/O Bucket 8.72ft in 2657mm
Clearance At Max Lift And Dump 7.24ft in 2205mm
Reach At Max Lift And Dump 17.01in 432mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.