Specification sheet Skid Steer Loader Ref bobcat-s450-skid-steer-loader

Bobcat S450

The Bobcat S450 is a skid steer loader with an operating weight of 5,026.54 lb (2,280 kg), a 49 hp engine, a rated operating capacity of 1,300 lb (589.68 kg), and a tipping load of 2,599.3 lb (1,179.02 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,026.54lb
2,280kg
Engine power
49hp
36.6kW
Gross Power
Rated operating capacity
1,300lb
589.68kg
Tipping load
2,599.3lb † — value reconstructed from related published figures
1,179.02kg

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S450 sits at the compact end of its class:

  • Operating weight 5,030 lb lighter than 86% (n=334)
  • Engine power 49 hp less powerful than 75% (n=335)
  • Rated operating capacity 1,300 lb lower-rated than 88% (n=288)

◇Scale drawingdrawn to scale · mm

1976C213D3173A2499B
Side elevation
1976C1488E
Front elevation

01 Engine Specification

Emission Tier Level Tier 4
Gross Power 49hp 36.6kw
Cooling System Liquid
Aspiration Turbocharged
Fuel Type Turbo Diesel

02 Operational Specification

Lift Arm Path Radius
Operational Weight 5026.6lb 2280kg
Fuel Capacity 14.4gal 54.6L
Max Speed 7.1mph 11.5km/h

03 Loader Specification

Loader Series M2-Series
Height To Hinge Pin 9.2ft in 2781mm
Operating Load Rating 1300lb 589.7kg
Bucket Width 62.1in 1575mm

04 Hydraulic Specification

Main Pump Flow Standard 16.7gal/min 63.3L/min
Relief Valve Pressure 3300psi 22752.7kPa

05 Dimensions Dimensions

Length With Bucket 10.42ft in 3173mm
Width Over Tires 4.89ft in 1488mm
Ground Clearance 8.39in 213mm
Height To Top Of Cab 6.49ft in 1976mm
Wheelbase 2.95ft in 899mm
Length W/O Bucket 8.2ft in 2499mm
Clearance At Max Lift And Dump 7.11ft in 2166mm
Reach At Max Lift And Dump 20.79in 528mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.