Specification sheet Skid Steer Loader Ref bobcat-s330-skid-steer-loader

Bobcat S330

The Bobcat S330 is a skid steer loader with an operating weight of 9,185 lb (4,166.25 kg), a 85 hp engine, a rated operating capacity of 3,300 lb (1,496.86 kg), and a tipping load of 6,720 lb (3,048.14 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
9,185lb
4,166.25kg
Engine power
85hp
63.4kW
Gross Power
Rated operating capacity
3,300lb
1,496.86kg
Tipping load
6,720lb † — value reconstructed from related published figures
3,048.14kg
Bucket capacity
0.7yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S330 sits at the heavy end of its class:

  • Operating weight 9,190 lb heavier than 94% (n=334)
  • Engine power 85 hp more powerful than 91% (n=335)
  • Rated operating capacity 3,300 lb higher-rated than 96% (n=288)

◇Scale drawingdrawn to scale · mm

2088C3630A2908B
Side elevation
2088C1868D
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V3800-DI-T
Gross Power 85hp 63.4kw
Power Measured @ 2575rpm
Displacement 231.9cu in 3.8L

02 Operational Specification

Operational Weight 9185lb 4166.3kg
Max Speed 12mph 19.4km/h
Operating Speed 6.9mph 11.2km/h

03 Loader Specification

Operating Load Rating 3300lb 1496.9kg
Bucket Capacity 0.7yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 20.7gal/min 78.4L/min

05 Dimensions Dimensions

Length With Bucket 11.91ft in 3630.17mm
Width Over Tires 6.13ft in 1868.43mm
Height To Top Of Cab 6.85ft in 2087.88mm
Wheelbase 4.03ft in 1228.35mm
Length W/O Bucket 9.54ft in 2907.8mm
Clearance At Max Lift And Dump 8.54ft in 2601mm
Reach At Max Lift And Dump 31.2in 792.48mm
Turning Radius From Center - Machine Rear 7.18in 182.38mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.