Specification sheet Skid Steer Loader Ref bobcat-s300-skid-steer-loader

Bobcat S300

The Bobcat S300 is a skid steer loader with an operating weight of 8,448 lb (3,831.95 kg), a 81 hp engine, a rated operating capacity of 3,000 lb (1,360.78 kg), and a tipping load of 6,111 lb (2,771.91 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
8,448lb
3,831.95kg
Engine power
81hp
60.5kW
Gross Power
Rated operating capacity
3,000lb
1,360.78kg
Tipping load
6,111lb † — value reconstructed from related published figures
2,771.91kg
Bucket capacity
0.6yd³
0.5m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S300 sits at the heavy end of its class:

  • Operating weight 8,450 lb heavier than 88% (n=334)
  • Engine power 81 hp more powerful than 81% (n=335)
  • Rated operating capacity 3,000 lb higher-rated than 91% (n=288)

◇Scale drawingdrawn to scale · mm

2055C3630A2908B
Side elevation
2055C1829D
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V3300-DI-T
Gross Power 81hp 60.5kw
Power Measured @ 2400rpm
Displacement 201.4cu in 3.3L

02 Operational Specification

Operational Weight 8448lb 3832kg
Fuel Capacity 23gal 87L
Max Speed 12mph 19.4km/h
Operating Speed 6.9mph 11.2km/h

03 Loader Specification

Operating Load Rating 3000lb 1360.8kg
Bucket Capacity 0.6yd3 0.5m3

04 Hydraulic Specification

Pump Flow Capacity 20.7gal/min 78.4L/min
Relief Valve Pressure 3300psi 22752.7kPa

05 Dimensions Dimensions

Length With Bucket 11.91ft in 3630mm
Width Over Tires 6.01ft in 1829mm
Height To Top Of Cab 6.75ft in 2055mm
Wheelbase 4.03ft in 1227mm
Length W/O Bucket 9.55ft in 2908mm
Clearance At Max Lift And Dump 8.29ft in 2525mm
Reach At Max Lift And Dump 34in 863.6mm
Turning Radius From Center - Machine Rear 84.2in 2138.68mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.