Specification sheet Skid Steer Loader Ref bobcat-s205-skid-steer-loader

Bobcat S205

The Bobcat S205 is a skid steer loader with an operating weight of 6,655 lb (3,018.66 kg), a 61 hp engine, a rated operating capacity of 2,050 lb (929.87 kg), and a tipping load of 4,100 lb (1,859.73 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,655lb
3,018.66kg
Engine power
61hp
45.5kW
Gross Power
Rated operating capacity
2,050lb
929.87kg
Tipping load
4,100lb † — value reconstructed from related published figures
1,859.73kg
Bucket capacity
0.6yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S205 sits in the middle of its class:

  • Operating weight 6,660 lb lighter than 54% (n=334)
  • Engine power 61 hp less powerful than 52% (n=335)
  • Rated operating capacity 2,050 lb higher-rated than 60% (n=288)

◇Scale drawingdrawn to scale · mm

1938C190D3310A2588B
Side elevation
1938C1676E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V2403-M-DI-T
Gross Power 61hp 45.5kw
Power Measured @ 2700rpm
Displacement 146.5cu in 2.4L

02 Operational Specification

Operational Weight 6655lb 3018.7kg
Fuel Capacity 24.1gal 91L
Max Speed 10.7mph 17.3km/h
Operating Speed 7mph 11.3km/h

03 Loader Specification

Operating Load Rating 2050lb 929.9kg
Bucket Capacity 0.6yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 16.3gal/min 61.8L/min

05 Dimensions Dimensions

Length With Bucket 10.86ft in 3310mm
Width Over Tires 5.5ft in 1676mm
Ground Clearance 7.49in 190mm
Height To Top Of Cab 6.36ft in 1938mm
Wheelbase 3.38ft in 1030mm
Length W/O Bucket 8.5ft in 2588mm
Clearance At Max Lift And Dump 7.58ft in 2310mm
Reach At Max Lift And Dump 29.6in 751.84mm
Turning Radius From Center - Inc Bucket 78.8in 2001.52mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.