Specification sheet Skid Steer Loader Ref bobcat-s185-skid-steer-loader
Bobcat S185
The Bobcat S185 is a skid steer loader with an operating weight of 6,220 lb (2,821.35 kg), a 56 hp engine, a rated operating capacity of 1,850 lb (839.15 kg), and a 0.5 yd³ (0.4 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
6,220lb
2,821.35kg
Engine power
56hp
41.8kW
Gross Power Rated operating capacity
1,850lb
839.15kg
Bucket capacity
0.5yd³
0.4m³
◆Where it sits in its classpercentile · skid steer loaders
Among 360 skid steer loaders , the Bobcat S185 sits below the median for its class:
- Operating weight 6,220 lb lighter than 63% (n=334)
- Engine power 56 hp less powerful than 66% (n=335)
- Rated operating capacity 1,850 lb lower-rated than 54% (n=288)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Engine Make | 2334 | |
| Engine Model | V2003-M-DI-T | |
| Gross Power | 56hp | 41.8kw |
| Power Measured @ | 2800rpm | |
| Displacement | 122.1cu in | 2L |
02 Operational Specification
| Operational Weight | 6220lb | 2821.4kg |
|---|---|---|
| Fuel Capacity | 24.1gal | 91L |
| Max Speed | 11.1mph | 17.9km/h |
| Operating Speed | 7.3mph | 11.8km/h |
03 Loader Specification
| Operating Load Rating | 1850lb | 839.2kg |
|---|---|---|
| Bucket Capacity | 0.5yd3 | 0.4m3 |
04 Hydraulic Specification
| Pump Flow Capacity | 16.9gal/min | 64L/min |
|---|---|---|
| Relief Valve Pressure | 3300psi | 22752.7kPa |
05 Dimensions Dimensions
| Length With Bucket | 10.86ft in | 3310mm |
|---|---|---|
| Width Over Tires | 5.5ft in | 1676mm |
| Ground Clearance | 7.49in | 190mm |
| Height To Top Of Cab | 6.36ft in | 1938mm |
| Wheelbase | 3.38ft in | 1030mm |
| Length W/O Bucket | 8.5ft in | 2588mm |
| Clearance At Max Lift And Dump | 7.58ft in | 2310mm |
| Reach At Max Lift And Dump | 29.65in | 753mm |
| Turning Radius From Center - Machine Rear | 78.8in | 2001.52mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.