Specification sheet Skid Steer Loader Ref bobcat-s160-skid-steer-loader

Bobcat S160

The Bobcat S160 is a skid steer loader with an operating weight of 6,115 lb (2,773.72 kg), a 56 hp engine, a rated operating capacity of 1,600 lb (725.75 kg), and a tipping load of 3,301 lb (1,497.31 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
6,115lb
2,773.72kg
Engine power
56hp
41.8kW
Gross Power
Rated operating capacity
1,600lb
725.75kg
Tipping load
3,301lb † — value reconstructed from related published figures
1,497.31kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S160 sits below the median for its class:

  • Operating weight 6,120 lb lighter than 68% (n=334)
  • Engine power 56 hp less powerful than 66% (n=335)
  • Rated operating capacity 1,600 lb lower-rated than 67% (n=288)

◇Scale drawingdrawn to scale · mm

1938C3310A2588B
Side elevation
1938C1676D
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V2003-M-DI-T
Gross Power 56hp 41.8kw
Power Measured @ 2800rpm
Displacement 122.1cu in 2L

02 Operational Specification

Operational Weight 6115lb 2773.8kg
Fuel Capacity 24.1gal 91L
Max Speed 11.1mph 17.9km/h
Operating Speed 7.3mph 11.8km/h

03 Loader Specification

Operating Load Rating 1600lb 725.8kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 26.4gal/min 100L/min
Relief Valve Pressure 3300psi 22752.7kPa

05 Dimensions Dimensions

Length With Bucket 10.86ft in 3310mm
Width Over Tires 5.5ft in 1676mm
Height To Top Of Cab 6.36ft in 1938mm
Wheelbase 3.38ft in 1030mm
Length W/O Bucket 8.5ft in 2588mm
Clearance At Max Lift And Dump 7.58ft in 2310mm
Reach At Max Lift And Dump 18.11in 459.74mm
Turning Radius From Center - Machine Rear 82.4in 2092.96mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.