Specification sheet Skid Steer Loader Ref bobcat-s150-skid-steer-loader

Bobcat S150

The Bobcat S150 is a skid steer loader with an operating weight of 5,935 lb (2,692.08 kg), a 46 hp engine, a rated operating capacity of 1,500 lb (680.39 kg), and a tipping load of 3,101 lb (1,406.59 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,935lb
2,692.08kg
Engine power
46hp
34.4kW
Gross Power
Rated operating capacity
1,500lb
680.39kg
Tipping load
3,101lb † — value reconstructed from related published figures
1,406.59kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S150 sits below the median for its class:

  • Operating weight 5,940 lb lighter than 69% (n=334)
  • Engine power 46 hp less powerful than 82% (n=335)
  • Rated operating capacity 1,500 lb lower-rated than 77% (n=288)

◇Scale drawingdrawn to scale · mm

1938C191D3310A2588B
Side elevation
1938C1676E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V2203-M-DI-E2B-BC-3
Gross Power 46hp 34.4kw
Power Measured @ 2800rpm
Displacement 134.3cu in 2.2L

02 Operational Specification

Operational Weight 5935lb 2692.1kg
Fuel Capacity 24.1gal 91L
Max Speed 7.3mph 11.8km/h
Operating Speed 7.3mph 11.8km/h

03 Loader Specification

Operating Load Rating 1500lb 680.4kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 16.9gal/min 64L/min
Relief Valve Pressure 3300psi 22752.7kPa

05 Dimensions Dimensions

Length With Bucket 10.86ft in 3310mm
Width Over Tires 5.5ft in 1676mm
Ground Clearance 7.52in 191mm
Height To Top Of Cab 6.36ft in 1938mm
Wheelbase 3.38ft in 1030mm
Length W/O Bucket 8.5ft in 2588mm
Clearance At Max Lift And Dump 7.21ft in 2197mm
Reach At Max Lift And Dump 18.15in 461mm
Turning Radius From Center - Machine Rear 82.4in 2092.96mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.