Specification sheet Skid Steer Loader Ref bobcat-s130-skid-steer-loader

Bobcat S130

The Bobcat S130 is a skid steer loader with an operating weight of 5,235 lb (2,374.56 kg), a 46 hp engine, a rated operating capacity of 1,300 lb (589.68 kg), and a tipping load of 2,634 lb (1,194.76 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,235lb
2,374.56kg
Engine power
46hp
34.4kW
Gross Power
Rated operating capacity
1,300lb
589.68kg
Tipping load
2,634lb † — value reconstructed from related published figures
1,194.76kg
Bucket capacity
0.4yd³
0.3m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S130 sits below the median for its class:

  • Operating weight 5,240 lb lighter than 84% (n=334)
  • Engine power 46 hp less powerful than 82% (n=335)
  • Rated operating capacity 1,300 lb lower-rated than 88% (n=288)

◇Scale drawingdrawn to scale · mm

1964C188D3152A2432B
Side elevation
1964C1490E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V2203-M-DI-E2B-BC-3
Gross Power 46hp 34.4kw
Power Measured @ 2400rpm
Displacement 134.3cu in 2.2L

02 Operational Specification

Operational Weight 5235lb 2374.6kg
Fuel Capacity 13.3gal 50L
Max Speed 7.3mph 11.8km/h
Operating Speed 7.3mph 11.8km/h

03 Loader Specification

Operating Load Rating 1300lb 589.7kg
Bucket Capacity 0.4yd3 0.3m3

04 Hydraulic Specification

Pump Flow Capacity 16.9gal/min 64L/min
Relief Valve Pressure 2600psi 17926.4kPa

05 Dimensions Dimensions

Length With Bucket 10.35ft in 3152mm
Width Over Tires 4.89ft in 1490mm
Ground Clearance 7.41in 188mm
Height To Top Of Cab 6.45ft in 1964mm
Wheelbase 2.96ft in 900mm
Length W/O Bucket 7.98ft in 2432mm
Clearance At Max Lift And Dump 6.9ft in 2101mm
Reach At Max Lift And Dump 22.6in 574.04mm
Turning Radius From Center - Machine Rear 68.7in 1744.98mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.