Specification sheet Skid Steer Loader Ref bobcat-s100-skid-steer-loader

Bobcat S100

The Bobcat S100 is a skid steer loader with an operating weight of 4,110 lb (1,864.27 kg), a 33.5 hp engine, a rated operating capacity of 1,000 lb (453.6 kg), and a tipping load of 2,039 lb (924.88 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
4,110lb
1,864.27kg
Engine power
33.5hp
25kW
Gross Power
Rated operating capacity
1,000lb
453.6kg
Tipping load
2,039lb † — value reconstructed from related published figures
924.88kg
Bucket capacity
0.3yd³
0.2m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Bobcat S100 sits at the compact end of its class:

  • Operating weight 4,110 lb lighter than 91% (n=334)
  • Engine power 34 hp less powerful than 93% (n=335)
  • Rated operating capacity 1,000 lb lower-rated than 92% (n=288)

◇Scale drawingdrawn to scale · mm

1878C2798A2262B
Side elevation
1878C1167D
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2334
Engine Model V1505
Gross Power 33.5hp 25kw
Power Measured @ 3000rpm
Displacement 91.6cu in 1.5L

02 Operational Specification

Operational Weight 4110lb 1864.3kg
Max Speed 6.5mph 10.5km/h
Operating Speed 6.5mph 10.5km/h

03 Loader Specification

Operating Load Rating 1000lb 453.6kg
Bucket Capacity 0.3yd3 0.2m3

04 Hydraulic Specification

Pump Flow Capacity 13.1gal/min 49.6L/min

05 Dimensions Dimensions

Length With Bucket 9.18ft in 2798.07mm
Width Over Tires 3.83ft in 1167.39mm
Height To Top Of Cab 6.16ft in 1877.57mm
Wheelbase 2.68ft in 816.87mm
Length W/O Bucket 7.42ft in 2261.62mm
Clearance At Max Lift And Dump 6.84ft in 2084mm
Reach At Max Lift And Dump 16.22in 411.99mm
Turning Radius From Center - Machine Rear 71.6in 1818.64mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.