Specification sheet Skid Steer Loader Ref belle-761xs-skid-steer-loader

Belle 761XS

The Belle 761XS is a skid steer loader with an operating weight of 5,381 lb (2,440.79 kg), a 48 hp engine, a rated operating capacity of 1,378 lb (625.06 kg), and a tipping load of 2,756 lb (1,250.1 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
5,381lb
2,440.79kg
Engine power
48hp
35.8kW
Net Power
Rated operating capacity
1,378lb
625.06kg
Tipping load
2,756lb † — value reconstructed from related published figures
1,250.1kg
Bucket capacity
0.5yd³
0.4m³

◆Where it sits in its classpercentile · skid steer loaders

Among 360 skid steer loaders , the Belle 761XS sits below the median for its class:

  • Operating weight 5,380 lb lighter than 82% (n=334)
  • Engine power 48 hp less powerful than 77% (n=335)
  • Rated operating capacity 1,380 lb lower-rated than 82% (n=288)

◇Scale drawingdrawn to scale · mm

2052C254D3024A2398B
Side elevation
2052C1475E
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2351
Engine Model 104-22
Net Power 48hp 35.8kw
Power Measured @ 2600rpm
Aspiration Natural
Displacement 135.3cu in 2.3L

02 Operational Specification

Operational Weight 5381lb 2440.8kg
Fuel Capacity 13.8gal 52L
Hydraulic System Fluid Capacity 14.6gal 55L
Tire Size 10 x 16.5

03 Loader Specification

Breakout Force 3616lb 1640.2kg
Operating Load Rating 1378lb 625.1kg
Bucket Capacity 0.5yd3 0.4m3

04 Hydraulic Specification

Pump Flow Capacity 15.9gal/min 60L/min
Relief Valve Pressure 2842psi 19594.9kPa

05 Dimensions Dimensions

Length With Bucket 9.93ft in 3024mm
Width Over Tires 4.84ft in 1475mm
Ground Clearance 10in 254mm
Height To Top Of Cab 6.74ft in 2052mm
Wheelbase 2.92ft in 890mm
Length W/O Bucket 7.87ft in 2398mm
Clearance At Max Lift And Dump 7.47ft in 2275mm
Reach At Max Lift And Dump 21.26in 540mm
Turning Radius From Center - Machine Rear 43.63in 1108mm
Turning Radius From Center - Inc Bucket 69.73in 1771mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.