Specification sheet Compact Track Loader Ref asv-sr70-multi-terrain-loader

ASV SR70

The ASV SR70 is a compact track loader with an operating weight of 7,890 lb (3,578.85 kg), a 68 hp engine, a rated operating capacity of 2,750 lb (1,247.38 kg), and a tipping load of 5,500 lb (2,494.76 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
7,890lb
3,578.85kg
Engine power
68hp
50.71kW
Net Power
Rated operating capacity
2,750lb
1,247.38kg
Tipping load
5,500lb † — value reconstructed from related published figures
2,494.76kg

◆Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the ASV SR70 sits below the median for its class:

  • Operating weight 7,890 lb lighter than 73% (n=182)
  • Engine power 68 hp less powerful than 69% (n=167)
  • Rated operating capacity 2,750 lb higher-rated than 51% (n=156)

◇Scale drawingdrawn to scale · mm

2184C381D3581A2845B1803E
Side elevation
2184C1676F
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make 2351
Engine Model 804C-33T
Gross Power 71hp 53kw
Net Power 68hp 50.8kw
Power Measured @ 2600rpm
Peak Torque 173lb ft 234.6Nm
Displacement 201.4cu in 3.3L
Aspiration turbocharged

02 Operational Specification

Operating Weight 7890lb 3578.9kg
Fuel Capacity 18gal 68.2L
Hydraulic System Fluid Capacity 21gal 79.5L

03 Loader Specification

Operating Load 2750lb 1247.4kg

04 Hydraulic Specification

Pump Flow 30gal/min 113.6L/min
Relief Valve Pressure 3000psi 20684.3kPa

05 Dimensions Dimensions

Width Over Tracks 5.5ft in 1676mm
Height To Top Of Cab 7.17ft in 2184mm
Ground Clearance 15in 381mm
Clearance At Max Lift And Dump 8.17ft in 2489mm
Reach At Max Lift And Dump 1.67ft in 508mm
Length With Bucket 11.75ft in 3581mm
Length With Out Bucket 9.34ft in 2845mm

06 Undercarriage Dimensions

Length Of Track On Ground 5.92ft in 1803mm
Track Gauge 4.25ft in 1295mm
Ground Contact Area 2123.51in2 1.37m2
Width Of Track 15in 381mm
Ground Pressure 3.7psi 25.5kPa

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.