Specification sheet Compact Track Loader Ref asv-rc85-multi-terrain-loader

ASV RC85

The ASV RC85 is a compact track loader with an operating weight of 9,710 lb (4,404.39 kg), a 86 hp engine, a rated operating capacity of 3,400 lb (1,542.22 kg), and a tipping load of 6,800 lb (3,084.43 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
9,710lb
4,404.39kg
Engine power
86hp
64.2kW
Gross Power
Rated operating capacity
3,400lb
1,542.22kg

Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the ASV RC85 sits in the middle of its class:

  • Operating weight 9,710 lb heavier than 60% (n=182)
  • Engine power 86 hp more powerful than 82% (n=167)
  • Rated operating capacity 3,400 lb higher-rated than 76% (n=156)

Scale drawingdrawn to scale · mm

2023C356D3760A2985B1842E
Side elevation
2023C1753F
Front elevation

01 Engine Specification

Engine Make 2351
Engine Model 1104C-44
Gross Power 86hp 64.2kw
Power Measured @ 2300rpm
Peak Torque 222lb ft 301Nm
Displacement 268cu in 4.4L
Aspiration naturally aspirated

02 Operational Specification

Operating Weight 9710lb 4404.4kg
Cooling System Fluid Capacity 3.2gal 12L
Fuel Capacity 26gal 98.5L
Engine Oil Capacity 2.2gal 8L
Hydraulic System Fluid Capacity 20.1gal 76L
Operating Voltage 12V
Alternator Supplied Amperage 65amps
Max Speed - High Range 6.1mph 9.7km/h

03 Loader Specification

Operating Load 3400lb 1542.3kg

04 Hydraulic Specification

Pump Flow 38gal/min 143.9L/min
Relief Valve Pressure 3300psi 22752.7kPa

05 Dimensions Dimensions

Width Over Tracks 5.76ft in 1753mm
Height To Top Of Cab 6.64ft in 2023mm
Ground Clearance 14.02in 356mm
Length With Out Bucket 9.8ft in 2985mm
Length With Bucket 12.34ft in 3760mm

06 Undercarriage Dimensions

Length Of Track On Ground 6.05ft in 1842mm
Track Gauge 4.26ft in 1296mm
Ground Contact Area 2604.01in2 1.68m2
Ground Pressure 3.3psi 22.7kPa
Width Of Track 18in 457mm

Data notes

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.