Specification sheet Compact Track Loader Ref asv-pt100-multi-terrain-loader

ASV PT100

The ASV PT100 is a compact track loader with an operating weight of 10,150 lb (4,604 kg), a 99.5 hp engine, a rated operating capacity of 3,800 lb (1,724 kg), and a tipping load of 7,600 lb (3,447.31 kg).

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Operating weight
10,150lb
4,604kg
Engine power
99.5hp
74kW
Gross Power
Rated operating capacity
3,800lb
1,724kg
Tipping load
7,600lb † — value reconstructed from related published figures
3,447.31kg

◆Where it sits in its classpercentile · compact track loaders

Among 184 compact track loaders , the ASV PT100 sits above the median for its class:

  • Operating weight 10,150 lb heavier than 70% (n=182)
  • Engine power 100 hp more powerful than 95% (n=167)
  • Rated operating capacity 3,800 lb higher-rated than 84% (n=156)

◇Scale drawingdrawn to scale · mm

2023C356D3760A2985B1842E
Side elevation
2023C1753F
Front elevation

01 Engine Specification

Engine Make 2351
Engine Model 1104C-44LT
Gross Power 99.5hp 74kw
Peak Torque 304lb ft 412Nm
Displacement 268cu in 4.4L
Aspiration Turbocharged

02 Operational Specification

Operating Weight 10150lb 4604kg
Cooling System Fluid Capacity 3.2gal 12L
Fuel Capacity 26gal 98L
Engine Oil Capacity 2.2gal 8.3L
Hydraulic System Fluid Capacity 20gal 76L
Max Speed - Low Range 6mph 9.7km/h
Max Speed - High Range 11.5mph 18.5km/h

03 Loader Specification

Operating Load 3800lb 1724kg

04 Hydraulic Specification

Pump Flow 38gal/min 144L/min
Relief Valve Pressure 3300psi 22737kPa

05 Dimensions Dimensions

Width Over Tracks 5.76ft in 1753mm
Height To Top Of Cab 6.64ft in 2023mm
Ground Clearance 14in 356mm
Length With Out Bucket 9.8ft in 2985mm
Length With Bucket 12.34ft in 3760mm

06 Undercarriage Dimensions

Length Of Track On Ground 6.05ft in 1842mm
Ground Contact Area 2610in2 1.68m2
Ground Pressure 3.8psi 26.7kPa
Number Of Track Rollers Per Side 21
Width Of Track 18in 457mm

Data notes

†

Derived value. tipping load was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.