Specification sheet Wheel Loader Ref volvo-l45h-wheel-loader

Volvo L45H

The Volvo L45H is a wheel loader with a 97.9 hp engine.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Engine power
97.9hp
73.1kW
Net Power

Where it sits in its classnot positioned

This machine has no published operating weight, so it cannot be placed in a wheel-loader weight band.

Scale drawingdrawn to scale · mm

2950B395C6370A
Side elevation
2950B2150D
Front elevation

01 Steering System Specification

Working Pressure 17.5 MPa, 2538 psi
Articulation Angle 40 degrees
Steering Cylinders 2
Maximum Flow 18.5gal/min 70L/min

02 Hydraulic Cycle Times (Unloaded) Specification

Lift 4.8sec
Lower 3.2sec
Dump Time 1.5sec

03 Electrical System Specification

Battery Capacity 2 x 100 Ah
Cold Cranking Capacity 830 A
Alternator Rating 3080/110 (W/A)
Starter Motor Output 7.4hp 5.5kw
Voltage 24 VV
Batteries 2 x 12 V

04 Engine Specification

Number Of Cylinders 4
Engine Model Volvo D4J
Net Power 97.9hp 73.1kw
Gross Power 100hp 74.6kw
Power Measured @ 2200rpm
Max Torque Gross - 425 Nm, Net - 416 Nm
Displacement 244.1cu in 4L
Torque Measured @ 1450rpm
Aspiration Turbocharged

05 Drive Train Specification

Transport Speed, Maximum 18.7mph 30km/h

06 Operational Specification

Def Tank Capacity 5.3gal 20L
Fuel Capacity 39.7gal 150L
Hydraulic System Fluid Capacity 25.1gal 95L
Engine Oil Fluid Capacity 3.7gal 14L
Cooling System Fluid Capacity 5.3gal 20L

07 Axles Specification

Rear Axle Oscillation 12degrees
Axle Oil Front 4.7gal 17.5L
Axle Oil Rear 4.7gal 17.5L

08 Hydraulic System Specification

Working Pressure 26 MPa, 3771 psi
Engine Speed 2200rpm
Pump Flow Capacity 34.9gal/min 132L/min

09 Bucket Dimensions

Breakout Force 15961.44lb 71kN

10 Dimensions Dimensions

Ground Clearance 1.3ft in 395mm
Length With Bucket On Ground 20.9ft in 6370mm
Width Over Tires 7.06ft in 2150mm
Height To Top Of Cab 9.68ft in 2950mm
Wheelbase 8.7ft in 2650mm
Hinge Pin - Max Height 12.09ft in 3685mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.