Specification sheet Wheel Loader Ref volvo-l25h-wheel-loader

Volvo L25H

The Volvo L25H is a wheel loader with a 63.5 hp engine.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Engine power
63.5hp
47.3kW
Net Power

Where it sits in its classnot positioned

This machine has no published operating weight, so it cannot be placed in a wheel-loader weight band.

Scale drawingdrawn to scale · mm

2485B290C5059A
Side elevation
2485B1740D
Front elevation

01 Steering System Specification

Working Pressure 21 MPa, 3046 bar
Articulation Angle 38 degrees
Steering Cylinders 1
Maximum Flow 8gal/min 30L/min

02 Hydraulic Cycle Times (Unloaded) Specification

Lift 5.2sec
Lower 3sec
Dump Time 3.9sec

03 Electrical System Specification

Battery Capacity 100 Ah
Alternator Rating 70 (W/A)
Starter Motor Output 3.4hp 2.5kw
Voltage 12 VV
Batteries 12 V

04 Engine Specification

Number Of Cylinders 4
Engine Model Volvo D2.6M
Net Power 63.5hp 47.3kw
Gross Power 64.4hp 48kw
Power Measured @ 2400rpm
Max Torque Gross - 225 Nm, Net - 221.6 Nm
Displacement 201.4cu in 3.3L
Torque Measured @ 1500rpm
Aspiration Turbocharged
Bore 3.5in 87mm
Stroke 4.4in 110mm

05 Drive Train Specification

Transport Speed, Maximum 18.7mph 30km/h

06 Operational Specification

Fuel Capacity 15.9gal 60L
Hydraulic System Fluid Capacity 15.6gal 59L
Engine Oil Fluid Capacity 2.7gal 10.2L
Cooling System Fluid Capacity 2.5gal 9.3L

07 Axles Specification

Axle Oil Front 1.1gal 4.1L
Axle Oil Rear 1.5gal 5.4L

08 Hydraulic System Specification

Working Pressure 3 MPa, 230 bar
Engine Speed 2400rpm
Pump Flow Capacity 14.6gal/min 55L/min

09 Bucket Dimensions

Bucket Width 5.91ft in 1800mm
Breakout Force 8317.94lb 37kN

10 Dimensions Dimensions

Ground Clearance 0.96ft in 290mm
Length With Bucket On Ground 16.6ft in 5059mm
Width Over Tires 5.71ft in 1740mm
Height To Top Of Cab 8.16ft in 2485mm
Wheelbase 6.73ft in 2050mm
Hinge Pin - Max Height 10.31ft in 3140mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.