Specification sheet Wheel Loader Ref new-holland-lw130tc-wheel-loader
New Holland LW130TC
The New Holland LW130TC is a wheel loader with a 140 hp engine.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Engine power
140hp
104.4kW
Net Power ◆Where it sits in its classnot positioned
This machine has no published operating weight, so it cannot be placed in a wheel-loader weight band.
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Make | 2358 | |
|---|---|---|
| Engine Model | 8065T | |
| Net Power | 140hp | 104.4kw |
| Gross Power | 130hp | 97kw |
| Max Torque | 412lb ft | 558.6Nm |
| Displacement | 360.1cu in | 5.9L |
| Aspiration | Turbocharged |
02 Operational Specification
| Fuel Capacity | 45gal | 170L |
|---|---|---|
| Hydraulic System Fluid Capacity | 27.8gal | 105L |
| Engine Oil Fluid Capacity | 3.2gal | 12L |
| Cooling System Fluid Capacity | 7.4gal | 28L |
| Transmission Fluid Capacity | 5.3gal | 20L |
| Front Axle/Diff Fluid Capacity | 5.6gal | 21L |
| Rear Axle/Diff Fluid Capacity | 7.7gal | 29L |
| Rear Axle Oscillation | 24degrees | |
| Tire Size | 20.5 x 25 XTLA |
03 Transmission Specification
| Transmission Type | powershift countershaft | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 4 | |
| Max Speed - Forward | 15.1mph | 24.2km/h |
| Max Speed - Reverse | 15.5mph | 24.9km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 3046psi | 21001.5kPa |
|---|---|---|
| Pump Flow Capacity | 43.6gal/min | 165L/min |
| Pump Type | sealed system with anticavitation and relief valves |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 8.8ft in | 2680mm |
|---|
06 Dimensions Dimensions
| Ground Clearance | 1.42ft in | 430mm |
|---|---|---|
| Length With Bucket On Ground | 23.92ft in | 7290mm |
| Height To Top Of Cab | 10.67ft in | 3250mm |
| Wheelbase | 9.52ft in | 2900mm |
| Hinge Pin - Max Height | 12.7ft in | 3870mm |
| Reach At Max Lift And Dump | 3.88ft in | 1180mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.