Specification sheet Backhoe Loader Ref new-holland-lb85-loader-backhoe
New Holland LB85
The New Holland LB85 is a backhoe loader with a 84.5 hp engine, a 1.31 yd³ (1 m³) bucket, and a dig depth of 14.67 ft (4,471 mm).
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Engine power
84.5hp
63kW
Gross Power Bucket capacity
1.31yd³
1m³
Dig depth
14.67ft
4,471mm
◆Where it sits in its classpercentile · backhoe loaders
Among 294 backhoe loaders , the New Holland LB85 sits in the middle of its class:
- Engine power 85 hp less powerful than 53% (n=282)
- Dig depth 14.7 ft deeper-digging than 56% (n=256)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Engine Model | NG Genises 450/NB | |
|---|---|---|
| Gross Power | 84.5hp | 63kw |
02 Operational Specification
| Operating Weight 4wd | 16016.6lb | 7265kg |
|---|---|---|
| Hydraulic System Fluid Capacity | 33.9gal | 128L |
03 Transmission Specification
| Transmission Type | power shuttle 2 | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 4 | |
| Max Speed - Forward | 24.2mph | 38.9km/h |
| Max Speed Reverse | 24.2mph | 38.9km/h |
04 Hydraulic Specification
| Pump Type | Gear | |
|---|---|---|
| Pump Flow Capacity | 39.9gal/min | 151L/min |
| Relief Valve Pressure | 3045.8psi | 21000kPa |
05 Backhoe Dimensions
| Load Height - Std | 12.31ft in | 3750mm |
|---|---|---|
| Reach From Swivel - Std | 18.15ft in | 5530mm |
| Dig Depth - Std | 14.67ft in | 4471mm |
| Bucket Dig Force - Std | 12652.33lb | 5739kg |
| Load At Max Lift - Std | 4629.71lb | 2100kg |
06 Dimensions Dimensions
| Transport Length | 18.67ft in | 5690mm |
|---|---|---|
| Transport Width | 7.47ft in | 2275mm |
| Transport Height | 13ft in | 3960mm |
07 Loader Dimensions
| Clearance At Max Dump Height | 11.59ft in | 3530mm |
|---|---|---|
| Lift Capacity At Full Height | 7826.42lb | 3550kg |
| Bucket Capacity | 1.31yd3 | 1m3 |
| Bucket Width | 89.57in | 2275mm |
| Bucket Breakout Force | _- | 61.74kN |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.