Specification sheet Wheel Loader Ref kawasaki-135ziv-2-wheel-loader
Kawasaki 135ZIV-2
The Kawasaki 135ZIV-2 is a wheel loader with an operating weight of 174,275.41 lb (79,050 kg), a 720 hp engine, and a 13.48 yd³ (10.3 m³) bucket.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld → Operating weight
174,275.41lb
79,050kg
Engine power
720hp
537kW
Net Power Bucket capacity
13.48yd³
10.3m³
◆Where it sits in its classpercentile · very large wheel loaders
Among 45 very large wheel loaders (>150,000 lb), the Kawasaki 135ZIV-2 sits below the median for its class:
- Operating weight 174,280 lb lighter than 82% (n=45)
- Engine power 720 hp less powerful than 59% (n=41)
◇Scale drawingdrawn to scale · mm
01 Engine Specification
| Number Of Cylinders | 12 | |
|---|---|---|
| Engine Make | 2347 | |
| Engine Model | QST30 | |
| Net Power | 720hp | 537kw |
| Power Measured @ | 2100rpm | |
| Max Torque | 2400lb ft | 3254Nm |
| Displacement | 1861cu in | 30.5L |
| Torque Measured @ | 1300rpm | |
| Aspiration | turbocharged & after cooled |
02 Operational Specification
| Operating Weight | 174275.5lb | 79050kg |
|---|---|---|
| Fuel Capacity | 277.4gal | 1050L |
| Hydraulic System Fluid Capacity | 192.9gal | 730L |
| Engine Oil Fluid Capacity | 35.2gal | 133L |
| Cooling System Fluid Capacity | 55.5gal | 210L |
| Transmission Fluid Capacity | 52.9gal | 200L |
| Front Axle/Diff Fluid Capacity | 83.8gal | 317L |
| Rear Axle/Diff Fluid Capacity | 83.8gal | 317L |
| Static Tipping Weight | 112987lb | 51250kg |
| Turning Radius | 31.8ft in | 9680mm |
| Operating Voltage | 24V | |
| Alternator Supplied Amperage | 75amps | |
| Rear Axle Oscillation | 22degrees | |
| Tire Size | 45/65-R39 (L-5) |
03 Transmission Specification
| Transmission Type | full powershift | |
|---|---|---|
| Number Of Forward Gears | 4 | |
| Number Of Reverse Gears | 3 | |
| Max Speed - Forward | 18.8mph | 30.3km/h |
| Max Speed - Reverse | 17mph | 27.4km/h |
04 Hydraulic System Specification
| Relief Valve Setting | 4550psi | 31371.2kPa |
|---|---|---|
| Pump Flow Capacity | 86.1gal/min | 326L/min |
| Raise Time | 9.8sec | |
| Dump Time | 1.6sec | |
| Lower Time | 4sec | |
| Pump Type | piston type |
05 Bucket Dimensions
| Dump Clearance At Max Raise | 14.59ft in | 4445mm |
|---|---|---|
| Bucket Capacity - Heaped | 13.48yd3 | 10.3m3 |
| Bucket Capacity - Struck | 11.51yd3 | 8.81m3 |
| Bucket Width | 14.51ft in | 4420mm |
| Breakout Force | 156526lb | 696.27kN |
06 Dimensions Dimensions
| Ground Clearance | 1.94ft in | 590mm |
|---|---|---|
| Length With Bucket On Ground | 40.72ft in | 12410mm |
| Width Over Tires | 13.65ft in | 4160mm |
| Height To Top Of Cab | 16.23ft in | 4945mm |
| Wheelbase | 15.75ft in | 4800mm |
| Hinge Pin - Max Height | 19.82ft in | 6040mm |
| Reach At Max Lift And Dump | 6.03ft in | 1837mm |
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.