Specification sheet Wheel Loader Ref john-deere-644a-wheel-loader

John Deere 644A

The John Deere 644A is a wheel loader with a 2.5 yd³ (1.92 m³) bucket.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Bucket capacity
2.5yd³
1.92m³

Where it sits in its classnot positioned

This machine has no published operating weight, so it cannot be placed in a wheel-loader weight band.

Scale drawingdrawn to scale · mm

3100B437C6300A
Side elevation

01 Engine Specification

Engine Make 2240
Power Measured @ 2400rpm
Max Torque 345lb ft 467.8Nm
Displacement 404cu in 6.7L
Torque Measured @ 1600rpm
Aspiration Turbocharged

02 Operational Specification

Fuel Capacity 50gal 189.3L
Hydraulic System Fluid Capacity 17.5gal 66.2L
Engine Oil Fluid Capacity 4.3gal 16.1L
Cooling System Fluid Capacity 9gal 34.1L
Transmission Fluid Capacity 9.8gal 36.9L
Front Axle/Diff Fluid Capacity 6gal 22.7L
Rear Axle/Diff Fluid Capacity 6.5gal 24.6L
Static Tipping Weight 18604lb 8439kg
Turning Radius 15.5ft in 4700.1mm
Operating Voltage 12V
Alternator Supplied Amperage 55amps
Rear Axle Oscillation 22degrees
Tire Size 16-24 / 20.5- 25

03 Transmission Specification

Transmission Type Powershift Transmission
Number Of Forward Gears 4
Number Of Reverse Gears 2
Max Speed - Forward 23mph 37km/h
Max Speed - Reverse 9.5mph 15.3km/h

04 Hydraulic System Specification

Relief Valve Setting 2250psi 15513.2kPa
Pump Flow Capacity 60gal/min 227L/min
Pump Type Variable displacement type pump

05 Bucket Dimensions

Dump Clearance At Max Raise 9.25ft in 2819.4mm
Breakout Force 41515lb 184.67kN
Bucket Capacity - Heaped 2.5yd3 1.92m3
Bucket Capacity - Struck 2.05yd3 1.57m3
Bucket Width 8.7ft in 2650mm

06 Dimensions Dimensions

Ground Clearance 1.44ft in 437mm
Length With Bucket On Ground 20.67ft in 6300.22mm
Height To Top Of Cab 10.17ft in 3099.82mm
Wheelbase 8.67ft in 2640mm
Hinge Pin - Max Height 11.85ft in 3610mm
Reach At Max Lift And Dump 2.92ft in 889mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.