JCB 5CX WASTE MASTER
The JCB 5CX WASTE MASTER is a backhoe loader with an operating weight of 17,861.9 lb (8,102 kg), and a 81 hp engine.
✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →◆Where it sits in its classpercentile · backhoe loaders
Among 294 backhoe loaders , the JCB 5CX WASTE MASTER sits in the middle of its class:
- Engine power 81 hp less powerful than 56% (n=282)
Not positioned on dig depth — withheld or unpublished for this machine.
01 Engine Specification
| Number Of Cylinders | 4 | |
|---|---|---|
| Rated Engine Speed | 2200rpm | |
| Gross Power | 81hp | 60.5kw |
| Aspiration | Turbocharged & Inter cooled | |
| Displacement | 268.6cu in | 4.4L |
| Bore | 4.1in | 103mm |
| Stroke | 5.2in | 132mm |
02 Operational Specification
| Operating Weight | 17861.9lb | 8102kg |
|---|---|---|
| Max Weight | 23369lb | 10600kg |
| Hydraulic System Fluid Capacity | 43.6gal | 165L |
03 Backhoe Dimensions
| Reach – Ground Level To Rear Wheel Center | 3.61ft in | 1.11m |
|---|---|---|
| Reach – Ground Level To Slew Center | 6.99ft in | 2.13m |
04 Dimensions Dimensions
| Kingpost Clearance | 1.65ft in | 0.5m |
|---|---|---|
| Pin Height | 11.36ft in | 3.46m |
| Width | 92.52in | 2350mm |
| Cab Roof Height | 9.95ft in | 3.03m |
| Dump Angle | 45degrees | |
| Steering Wheel Centre Height | 6.17ft in | 1.88m |
| Total Travel Length | 265.36in | 6740mm |
| Travel Clearance | 142.13in | 3.61m |
| Axle Centreline Distance | 7283.47ft in | 2220m |
| Rear Frame Width | 7.75ft in | 2.36m |
| Rollback @ Ground | 45degrees | |
| Slew Centre To Rear Axle Center Distance | 4.47ft in | 1.36m |
| Stabiliser Feet Clearance | 1.12ft in | 0.34m |
05 Loader Dimensions
| Load Over Height | 10.44ft in | 3.18m |
|---|---|---|
| Dump Height | 8.83ft in | 2.69m |
| Rollback - Ground Level | 45degrees |
Data notes
Derived value. engine power was not published directly in a usable form by the source. It was reconstructed from related published figures and accepted only after validating against the expected relationship between specifications for this machine class.
Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.