Specification sheet Wheel Loader Ref case-w11b-wheel-loader

Case W11B

The Case W11B is a wheel loader with a 66 hp engine, and a 0.75 yd³ (0.57 m³) bucket.

✓ QA-verified — every figure checked for unit consistency, physical possibility, and class plausibility; failures withheld →
Engine power
66hp
49.3kW
Net Power
Bucket capacity
0.75yd³
0.57m³

Where it sits in its classnot positioned

This machine has no published operating weight, so it cannot be placed in a wheel-loader weight band.

Scale drawingdrawn to scale · mm

2410B254C5230A
Side elevation
2410B1790D
Front elevation

01 Engine Specification

Number Of Cylinders 4
Engine Make Case
Engine Model 4-390
Net Power 66hp 49.3kw
Gross Power 71hp 53kw
Power Measured @ 2100rpm
Displacement 239.3cu in 4L
Net Torque 178lb ft 241.3Nm
Torque Measured @ 1200rpm
Bore 4.1in 102mm
Stroke 4.8in 120mm

02 Operational Specification

Fuel Capacity 28.1gal 106L
Hydraulic System Fluid Capacity 14.1gal 53L
Engine Oil Fluid Capacity 3gal 11L
Cooling System Fluid Capacity 5.1gal 19L
Transmission Fluid Capacity 3.6gal 13.3L
Turning Radius 27.4ft in 8330mm
Operating Voltage 12V
Alternator Supplied Amperage 42amps
Rear Axle Oscillation 24degrees
Tire Size 15.00 X19.5

03 Transmission Specification

Transmission Type Power shift
Number Of Forward Gears 3
Number Of Reverse Gears 3
Max Speed - Forward 22.3mph 35.9km/h
Max Speed - Reverse 22.3mph 35.9km/h

04 Hydraulic System Specification

Pump Flow Capacity 26gal/min 98.4L/min
Raise Time 5.2sec
Dump Time 1.9sec
Lower Time 5.3sec
Total Cycle 12.4sec
Pump Type Dual tandem

05 Bucket Dimensions

Dump Clearance At Max Raise 4.43ft in 1350mm
Bucket Capacity - Heaped 0.75yd3 0.57m3
Bucket Capacity - Struck 0.67yd3 0.51m3
Breakout Force 110076797.99lb 489646.04kN

06 Dimensions Dimensions

Ground Clearance 0.84ft in 254mm
Length With Bucket On Ground 17.16ft in 5230mm
Width Over Tires 5.88ft in 1790mm
Height To Top Of Cab 7.91ft in 2410mm
Wheelbase 7.68ft in 2340mm
Hinge Pin - Max Height 10.34ft in 3150mm
Reach At Max Lift And Dump 3.35ft in 1020mm

Method. Figures are manufacturer reference specifications, not measurements. Every value is checked for unit consistency, physically possible magnitude, and plausibility for its equipment class before publication; figures that fail any check are withheld rather than shown, and figures reconstructed from related data are marked above. Imperial and metric figures are reproduced as published, except where a note states otherwise.